Rhode Island CDL: Tanker Vehicles Practice Test

Not quite. The answer is should avoid braking as you're turning.

The liquid cargo can surge both back and forth and side to side. This makes a skid more likely if you brake in a sharp turn. And it also makes it more likely that the skid will lead to a rollover.

Not quite. The answer is may exceed legal weight limits.

A full tank of dense liquid (such as some acids) may exceed legal weight limits. For this reason, you may not be able to completely fill the tank with a dense liquid.

Not quite. The answer is 1,000 gallons or more.

Federal regulations define a "tank vehicle" as a commercial motor vehicle designed to transport liquids or gases within tanks that have an individual rated capacity of more than 119 gallons each and an aggregate rated capacity of 1,000 gallons or more. To drive such tank vehicles, you must have a Tank (N) endorsement or Combination Hazmat and Tank (X) endorsement on your CDL.

Source: 49 CFR § 383.5

Not quite. The answer is 9,000 gallons.

The average capacity of a DOT-406 or MC-306 fuel delivery truck (often called a "gasoline truck") is 9,000 gallons.

Not quite. The answer is At the start of each trip and each time you stop

If you have a placarded trailer with dual tires, you should check the tires at the start of each trip and each time that you stop for any reason, whether to rest or to refuel. Use a tire pressure gauge to get an accurate reading.

Not quite. The answer is Set the parking brake and pull forward gently.

The parking brake is meant to keep your vehicle from moving. The best way to test it is to apply the parking brake and then try to pull forward gently. The parking brake should hold your vehicle in place. If you're pulling one or more trailers, test each trailer's parking brakes in the same way.

Not quite. The answer is Upshift.

If your hydraulic brakes fail while you're driving, try pumping the brake pedal to build up enough hydraulic pressure to stop your vehicle. If this fails, downshift to use engine braking and apply the parking brake. Release the parking brake before you lock the wheels. If all else fails, look for an escape route. Head for an escape ramp or an open field and let your vehicle slow to a stop.

Not quite. The answer is Slow to a safe speed before entering, then accelerate slightly through the curve.

The posted speed for a curve may be safe for cars but not for tankers because of their relatively high center of gravity. Tests have shown that a tanker can roll over on a curve when traveling at the posted speed. The safest way to take a curve in a tanker is to slow down before the curve and then accelerate slightly through the curve. Braking in a curve risks a skid.

Not quite. The answer is Wet roads can double the stopping distance at any speed.

To control surge, know the stopping distance of your vehicle and brake far in advance of a stop whenever possible. Bear in mind that your vehicle's stopping distance on wet roads will be about double its stopping distance on dry roads.

Not quite. The answer is Both of the above

It takes special skills to drive a tanker carrying liquid cargo because of the vehicle's high center of gravity and the possibility that the liquid cargo may surge forward and backward or from side to side. The high center of gravity increases the risk of a rollover. And the liquid surge can push the vehicle dangerously forward or sideways, which can also cause a rollover.

Not quite. The answer is speed up slightly

The posted speed for a curve may be safe for cars but not for tankers because of their relatively high center of gravity. Tests have shown that a tanker can roll over on a curve when traveling at the posted speed. The safest way to take a curve in a tanker is to slow down before the curve and then accelerate slightly through the curve.

Not quite. The answer is you have to press the brake pedal harder than usual to control your speed.

If your brakes begin to fade, you'll notice that you have to depress the brake pedal harder to achieve the same braking effect as before. If your vehicle is so equipped, check the application pressure gauge to see just how much pedal effort you are employing. If the brakes continue to fade, you may not be able to slow down or stop at all.

Not quite. The answer is roll over.

Baffled tanks can control back-and-forth surge but not side-to-side surge. During sudden steering changes, side-to-side surge can cause your tanker to roll over. Avoid such sudden moves when possible.

Not quite. The answer is At the end of each working day

Oil and water can start to collect in the bottom of an air tank and can cause brake failure if it's not drained. Unless your vehicle automatically drains the air tanks, you should drain them at the end of each working day so the moisture and oil will not freeze or coagulate and cause your brakes to fail.

Not quite. The answer is four

You placard your vehicle to warn everyone around you that you are transporting hazardous materials. Therefore, you must have placards on all four sides of your vehicle.

Not quite. The answer is Environment

The S.T.A.M.P.E.D. acronym is widely used to assist you in obtaining the correct hoses and fittings for your needs. S: the required size of the hose; T: the temperatures to which the hose will be subjected; A: the application (use) to which the hose will be put; M: the types of material (liquid, gas, etc.) that will have to flow through the hose; P: the maximum working pressure of the hose; E: the required fittings at the ends of the hose; D: the date at which the hose must be delivered to you.

Not quite. The answer is Always

Escape ramps are designed with soft gravel, upgrades, or both, to slow down vehicles that experience brake failure on a downgrade. Regardless of the type of CMV you're driving, if your brakes have failed, head for one of these escape ramps, which can save lives, equipment, and cargo.

Not quite. The answer is your vehicle may jackknife.

If your drive wheels are skidding, it's likely because you applied the brakes too hard and locked the drive wheels. A drive-wheel skid can let the trailer push the tractor sideways, causing a sudden jackknife. To recover from this type of skid, the first thing to do is stop braking. The drive wheels will unlock and start to roll again.

Not quite. The answer is Within 500 feet behind the vehicle

If you park on the side of the road and the view of your vehicle is obscured by a hill or curve, place a reflective triangle far enough (up to 500 feet) behind your vehicle so it can be seen by other drivers.

Not quite. The answer is The posted speed for a curve may be too fast for a tank vehicle.

Tank vehicles have a high center of gravity. Much of a loaded tanker's weight is carried five or six feet above the ground. This makes a tanker top-heavy, which makes it more prone to rollovers than other types of vehicles. Tests have shown that a tank vehicle can roll over at the speed limits posted for curves. The safest way to take a curve in a tanker is to slow down well below the posted speed limit before you enter the curve.