Rhode Island CDL: Combination Vehicles Practice Test

Not quite. The answer is None

If there is space between the lower and upper fifth wheel after you have finished coupling, something is wrong. Perhaps the kingpin is on top of the closed fifth-wheel jaws, which could result in the trailer coming loose. Don't start to drive until you have identified and fixed the problem.

Not quite. The answer is two red lights

According to federal regulations, if the load projects more than 4 feet behind the rear of the vehicle, the end of the load must be marked as follows: (1) with two red flags, each 18 inches square, in the daytime; or (2) with two red lights at night. There are additional federal requirements on how to illuminate the rest of the load. US states may impose their own additional requirements on the transportation of oversized loads. You can learn about Rhode Island's requirements by contacting the Rhode Island Department of Transportation or visiting their webpage "RI DOT Oversize/Overweight Permits" (https://www.ri.gov/DOT/osow). [49 CFR 393.11],

Source: 49 CFR 393.87

Not quite. The answer is release the brakes.

Once you realize your vehicle is in a skid, you should release the brakes so that the wheels can grip the road again. The trailer will start to follow the tractor and straighten out.

Not quite. The answer is It controls the emergency brakes on combination vehicles.

The emergency air line is often colored red. It supplies air to the trailer air tanks and controls the emergency brakes on combination vehicles.

Not quite. The answer is The trailer emergency brakes will come on.

If the emergency (supply) air line breaks, the tractor protection valve will close to stop any more compressed air from leaving the tractor. Hence, the tractor's service brakes should still work. However, the loss of trailer air pressure from the ruptured line will cause the trailer emergency (spring) brakes to come on.

Not quite. The answer is Push in the trailer air supply valve control.

The control for the trailer air supply valve is an eight-sided red knob on the dashboard. You push the knob in to supply compressed air to the trailer air brake system. You pull the knob out to evacuate air from the trailer air brake system (which will set the trailer brakes).

Not quite. The answer is To prevent steering problems

There shouldn't be any space between the upper and lower fifth wheel. However, friction could cause steering problems. To reduce friction, make sure that the fifth wheel plate is well lubricated as required.

Not quite. The answer is It takes 14 seconds to clear a single track and more than 15 seconds to clear a double track.

You can expect it to take more than 15 seconds for a typical tractor-trailer to clear a double track and at least 14 seconds to clear a single track.

Not quite. The answer is the tractor protection valve control (trailer air supply control) will pop out or go from "normal" to "emergency."

When you test the tractor protection valve, the tractor protection valve control (also called the trailer air supply control) should pop out or go from the "normal" to the "emergency" position. This shows that the tractor protection valve has closed automatically to keep the air pressure from falling too far.

Not quite. The answer is red; blue

To keep the air lines from being mismatched, they can be labeled with metal tags or color coded. Blue is used for the service lines, and red is used for the emergency lines. Couple the air lines of the same color.

Not quite. The answer is low gear.

Start to raise the landing gear by using the low gear range (if the landing gear is so equipped). Then switch to the high gear range once the trailer supports are free of weight.

Not quite. The answer is a fully loaded trailer

Trucks brake best when they are used as they were designed: to carry a properly balanced load. Empty trucks actually have longer stopping distances than loaded trucks because they have less traction. The stiff suspension springs and strong brakes give poor traction and make it easier to lock the wheels.

Not quite. The answer is the trailer is still less likely to swing out.

Even if only the trailer has ABS, there is less chance that its wheels will lock and it will swing out, though it can still happen. If it does, let up on the brakes until you regain control.

Not quite. The answer is at normal pressure.

During the coupling process, after you have connected the tractor air lines to the trailer, push in the trailer air supply valve to fully charge the trailer air brake system with compressed air. Make sure that the trailer air brakes are working before you proceed with the rest of the coupling process.

Not quite. The answer is the brakes on the trailer wheels caused the skid in the first place.

The trailer hand valve (also known as a trolley valve or Johnson bar) controls only the trailer brakes, not the tractor brakes. If you're already jackknifing because the trailer wheels locked up, applying the trailer brakes with the hand valve can make it even worse. Instead, stop braking. The rear wheels will start to roll again and you can steer to correct the skid.

Not quite. The answer is On the left front or left rear corner

On a trailer, the yellow ABS malfunction lamp is located on the left front or left rear corner. Make sure you know where to look for it.

Not quite. The answer is Always

If there is a leak in the emergency air line, air will eventually leak out of the trailer air tank. If the trailer has air brakes but not spring brakes, the brakes will fail. Use chocks to prevent the trailer from rolling if its brakes fail.

Not quite. The answer is use controlled or stab braking.

Hard braking and turning at the same time is likely to cause a skid. You should brake in a way that will keep your vehicle in a straight line and allow you to turn if necessary. If you need to brake suddenly to avoid a crash, use controlled braking or stab braking (but don't use stab braking if your vehicle has antilock brakes).

Not quite. The answer is When you lock the drive wheels on the tractor and the tractor spins out sideways as the trailer continues to push forward

A jackknife is usually the result of a drive-wheel skid. The tractor's rear drive wheels lock, and the trailer starts to push the tractor sideways.

Not quite. The answer is empty.

Trucks brake best when they are used as they were designed: to carry a properly balanced load. When a combination vehicle is empty or lightly loaded, its braking distance increases. The very stiff suspension springs and strong brakes give poor traction and make it very easy to lock the wheels.