Pennsylvania CDL: Combination Vehicles Practice Test

Not quite. The answer is get away from your vehicle and call 911 or the posted emergency number.

A train traveling at 60 mph can take more than a mile to come to a complete stop. If your vehicle gets stuck on a railroad track, don't spend any time trying to free your vehicle. Get out of your vehicle and walk quickly at about a 45-degree angle to the tracks in the direction from which you expect trains to approach. That way, if your vehicle is hit, you won't be struck by flying debris. Call 911 or the telephone number on the railroad crossing sign for assistance.

Not quite. The answer is trailer emergency brakes to come on.

With the loss of air pressure, the tractor protection valve will close and the trailer emergency brakes will come on.

Not quite. The answer is it will be raised slightly when the tractor is backed under it.

Before backing the tractor under the trailer, adjust the landing gear to position the trailer at the proper height. The trailer should be just low enough that it will be raised slightly by the tractor when the tractor backs under it. If the trailer is too low, the tractor may hit and damage the trailer nose; if it's too high, it may not couple properly.

Not quite. The answer is the coupling surface of the trailer is just below the middle of the tractor fifth wheel.

The tractor fifth wheel should tilt downward toward the trailer. As you start to back the tractor under the trailer, the coupling surface of the trailer should be just below the middle of the tractor fifth wheel.

Not quite. The answer is opening the emergency line shut-off valve and then the service line valve at the rear of the last trailer and listening for air escaping each time.

To check whether air is flowing to all trailers, go to the rear of the last trailer and open the emergency line shut-off valve there. If the entire system is charged, you should hear air escaping. Then close that valve and open the service line valve. Again, you should hear air escaping.

Not quite. The answer is Gently pull forward in low gear against the locked trailer brakes; then look at it carefully.

After you've backed under the trailer and locked the kingpin into the fifth wheel, raise the landing gear slightly. Then with the trailer brakes still locked, gently pull the tractor forward to check that the trailer is locked onto the tractor.

Not quite. The answer is Turn wide as you complete the turn.

To turn right, you must turn wide to help prevent the rear end of your vehicle from overrunning the curb. However, if you swing wide to the left before you turn right, another driver may try to pass you on your right, which can lead to a collision. Instead, start the right turn with the rear of your vehicle as close to the curb as possible and then turn wide as you complete the turn. This will deny drivers room on the right to try to pass you.

Not quite. The answer is Turn wide as you complete the turn.

If you swing wide to the left before you turn right, another driver may try to pass you on your right, which can lead to a collision. Instead, start the right turn with the rear of your vehicle as close to the curb as possible and then turn wide as you complete the turn. This will deny drivers room on the right to try to pass you.

Not quite. The answer is Always

If there is a leak in the emergency air line, air will eventually leak out of the trailer air tank. If the trailer has air brakes but not spring brakes, the brakes will fail. Use chocks to prevent the trailer from rolling if its brakes fail.

Not quite. The answer is "Bobtail" tractors can take longer to stop than a combination vehicle loaded to the maximum gross weight.

When a combination vehicle is empty or lightly loaded, its braking distance increases. The very stiff suspension springs and strong brakes give poor traction and make it very easy to lock the wheels. Likewise, "bobtail" tractors (tractors without semitrailers) can take longer to stop than a fully loaded tractor-trailer. Be very careful when driving a "bobtail" tractor.

Not quite. The answer is It controls the emergency brakes on combination vehicles.

The emergency air line is often colored red. It supplies air to the trailer air tanks and controls the emergency brakes on combination vehicles.

Not quite. The answer is 4 psi per minute.

After the initial drop, the maximum acceptable leakage rates with the service brakes on are 3 psi per minute for single vehicles and 4 psi per minute for combination vehicles. If the leakage rate is higher, check for leaks and correct them.

Not quite. The answer is Neutral

Before you inspect the trailer supports of the landing gear, secure the tractor by applying the parking brake and placing the transmission in Neutral.

Not quite. The answer is ten times as likely to roll over in a crash as empty rigs.

When you stack cargo high in a trailer, you raise its center of gravity, which makes the trailer more prone to rolling over. A fully loaded tractor-trailer is ten times as likely to roll over in a crash as an empty one.

Not quite. The answer is the trailer brakes are locked.

During coupling, before backing under the trailer, set the trailer air supply control to shut off the air and lock the trailer brakes. On newer vehicles, this control is an eight-sided red knob. You pull it out to shut off the air.

Not quite. The answer is It is used to supply the trailer with air, shut the air off, and apply the trailer emergency brakes.

On newer vehicles, the trailer air supply control is an eight-sided red knob on the dashboard of the tractor. The knob may be labeled "Pull to exhaust...Push to supply" or something similar. When you push the knob in, air will flow through the trailer's emergency air lines to charge the trailer air brake system. Pulling out the knob shuts off the flow of air and causes the trailer emergency brakes to come on.

Not quite. The answer is slightly raised.

After you've backed under the trailer and locked the kingpin into the fifth wheel, raise the landing gear slightly. Then with the trailer brakes still locked, gently pull the tractor forward to check that the trailer is locked onto the tractor.

Not quite. The answer is glad hands

As part of your vehicle inspection test, if your vehicle is equipped with air brakes and has a trailer, you will inspect the air connections between the truck or tractor and the trailer. These connections are made with hose couplers (commonly called "glad hands" because they vaguely resemble shaking hands). These glad hands have rubber seals to form a tight connection and prevent air from escaping. Make sure that the glad hands are locked in place and free of damage or air leaks.

Not quite. The answer is The rear wheels of the last trailer

Off-tracking is defined as the different paths taken by the front and rear wheels in a turn. The longer the vehicle, the greater the difference will be. Thus, the wheels on the front trailer will offtrack more than the tractor's rear wheels, and the wheels on the rearmost trailer will offtrack most of all.

Not quite. The answer is 20 to 45 psi.

The tractor protection valve is located in the tractor, usually at the rear of the cab. Its purpose is to keep air in the tractor's air brake system should the trailer break away or develop a bad leak. The tractor protection valve is designed to close automatically if the air pressure falls into the range specified by the manufacturer, typically 20–45 psi.