Montana CDL: Combination Vehicles Practice Test

Not quite. The answer is emergency

The tractor protection valve keeps air in the tractor if the trailer breaks away or develops a bad leak. If air pressure drops too low in the service line, the tractor protection valve will close. This stops air from escaping from the tractor and lets air out of the trailer emergency line, causing the trailer emergency brakes to come on.

Not quite. The answer is the emergency and service air lines.

Before backing under the trailer, you must lock the trailer brakes – which means that you first have to make sure that the trailer brakes are working. Connect the emergency and service air lines and test the trailer brakes.

Not quite. The answer is open except for those on the last trailer.

The shut-off valves are located at the rear of each trailer to allow you to stop the air flow there. If there is another trailer behind this one, open the valves to allow air to flow to that trailer; otherwise, close the valves.

Not quite. The answer is it will be raised slightly when the tractor is backed under it.

Before backing the tractor under the trailer, adjust the landing gear to position the trailer at the proper height. The trailer should be just low enough that it will be raised slightly by the tractor when the tractor backs under it. If the trailer is too low, the tractor may hit and damage the trailer nose; if it's too high, it may not couple properly.

Not quite. The answer is The shank

Don't drive the vehicle until you're sure that the coupling is correct. Check to make sure of the following: There is no space between the upper and lower fifth wheel, the fifth wheel jaws have closed around the shank of the kingpin, the locking lever is in the "lock" position, and the safety latch is in position over the locking lever. If anything isn't right, don't drive the vehicle until you've found and corrected the problem. If you drive it anyway, your trailer could come loose while you're driving.

Not quite. The answer is Control line and signal line

The service air line is also known as the control line or signal line.

Not quite. The answer is 20 to 45 psi.

The tractor protection valve is located in the tractor, usually at the rear of the cab. Its purpose is to keep air in the tractor's air brake system should the trailer break away or develop a bad leak. The tractor protection valve is designed to close automatically if the air pressure falls into the range specified by the manufacturer, typically 20–45 psi.

Not quite. The answer is Adjust the air supply knob to send air to the trailer brakes. Turn off the engine once the air pressure normalizes. Then listen for the sound of escaping air as the brakes are released.

After coupling, make sure that the air lines are not crossed. To do this, send air to the trailer brakes by adjusting the "air supply" knob to normal. Let the pressure normalize. Then turn off the engine and test the brakes. You should see and hear the brakes in action and then see the air pressure normalize again.

Not quite. The answer is the tractor protection valve to close.

The tractor protection valve keeps air in the tractor if the trailer breaks away or develops a bad leak. If air pressure drops too low in the service line, the tractor protection valve will close. This stops air from escaping from the tractor and lets air out of the trailer emergency line, causing the trailer emergency brakes to come on.

Not quite. The answer is Normal

To test the trailer air brake system, first charge it with air. Push in the red trailer air supply knob, or place the tractor protection valve control in the "normal" position. Wait until the air pressure reaches normal before you start your tests.

Not quite. The answer is always use the lowest reverse gear.

When coupling, use the lowest reverse gear and back slowly to avoid hitting or damaging the kingpin.

Not quite. The answer is secured but with enough slack for turns.

During your walk-around inspection, make sure that the electrical and air lines are secure but have enough slack to stay attached and secure even when the vehicle is turning.

Not quite. The answer is No, because the brakes on the trailer wheels caused the skid to begin with.

The trailer skid was caused by the brakes locking the wheels. Applying the trailer hand brake might make that even worse. Instead, release the brakes so the trailer wheels can roll again and regain traction.

Not quite. The answer is trailer emergency brakes to come on.

With the loss of air pressure, the tractor protection valve will close and the trailer emergency brakes will come on.

Not quite. The answer is It will keep dirt and water out of the lines.

Some vehicles are equipped with "dead-end" or dummy couplers. When the air lines are not connected to a trailer, connect the glad hands to the dummy couplers to keep water and dirt out of the glad hands and air lines. If your vehicle doesn't have dummy couplers, you may be able to connect the glad hands to each other.

Not quite. The answer is Turn wide as you complete the turn.

To turn right, you must turn wide to help prevent the rear end of your vehicle from overrunning the curb. However, if you swing wide to the left before you turn right, another driver may try to pass you on your right, which can lead to a collision. Instead, start the right turn with the rear of your vehicle as close to the curb as possible and then turn wide as you complete the turn. This will deny drivers room on the right to try to pass you.

Not quite. The answer is On the left front or left rear corner

On a trailer, the yellow ABS malfunction lamp is located on the left front or left rear corner. Make sure you know where to look for it.

Not quite. The answer is makes firm contact with the ground.

When uncoupling a loaded trailer, lower the landing gear until it makes firm contact with the ground. Then crank the landing gear in low gear for a few more turns – just enough to lift some weight off the tractor, but not so much that you lift the trailer off the fifth wheel. This will make it easier to unlatch the fifth wheel now and couple next time.

Not quite. The answer is red; blue

To keep the air lines from being mismatched, they can be labeled with metal tags or color coded. Blue is used for the service lines, and red is used for the emergency lines. Couple the air lines of the same color.

Not quite. The answer is Both of these statements are true.

The trailer hand valve (also known as a trolley valve or Johnson bar) controls only the trailer brakes, not the tractor brakes. You can use it to test the trailer brakes. Don't use it while you're driving, though. If you apply it while you're driving, you'll brake the trailers but not the tractor, which can cause a skid. Instead, use the foot brake, which sends air to the tractor brakes as well as the trailer brakes.