Missouri CDL: Combination Vehicles Practice Test

Not quite. The answer is applying and releasing the trailer brakes and listening for brake sounds.

After you've connected the air lines, double-check the connection and make sure the brakes are working. Shut off the engine so you can hear the brakes. Apply the brakes and listen for the sound of the brakes being applied. Release the brakes and listen for the hiss of escaping air.

Not quite. The answer is To prevent steering problems

One of the first steps in coupling a tractor to a trailer is to check that the fifth wheel skid plate is greased as required. If the fifth wheel plate is not properly lubricated, friction between the plate and the trailer apron could cause steering problems.

Not quite. The answer is it will be raised slightly when the tractor is backed under it.

Before backing the tractor under the trailer, adjust the landing gear to position the trailer at the proper height. The trailer should be just low enough that it will be raised slightly by the tractor when the tractor backs under it. If the trailer is too low, the tractor may hit and damage the trailer nose; if it's too high, it may not couple properly.

Not quite. The answer is Always

If there is a leak in the emergency air line, air will eventually leak out of the trailer air tank. If the trailer has air brakes but not spring brakes, the brakes will fail. Use chocks to prevent the trailer from rolling if its brakes fail.

Not quite. The answer is they are more likely to get stuck on raised railroad crossings.

The two types of combination vehicles most likely to get stuck at a raised railroad crossing are low-slung units (car carriers, lowboys, moving vans, etc.) and single-axle tractors that are pulling a long trailer with its landing gear set to accommodate a tandem-axle tractor. Be very careful when driving such vehicles at railroad crossings.

Not quite. The answer is a fully loaded trailer

Trucks brake best when they are used as they were designed: to carry a properly balanced load. Empty trucks actually have longer stopping distances than loaded trucks because they have less traction. The stiff suspension springs and strong brakes give poor traction and make it easier to lock the wheels.

Not quite. The answer is None

If there is space between the lower and upper fifth wheel after you have finished coupling, something is wrong. Perhaps the kingpin is on top of the closed fifth-wheel jaws, which could result in the trailer coming loose. Don't start to drive until you have identified and fixed the problem.

Not quite. The answer is A tractor pulling three trailers

The last trailer of a triple is 3.5 times more likely to roll over than a five-axle tractor. This is known as the crack-the-whip effect. When pulling a triple, increase your following distance, avoid sudden moves, and steer gently. At night, don't drive faster than your headlight range.

Not quite. The answer is The trailer emergency brakes will come on.

The trailer air supply valve (which is manually controlled by the red dashboard knob) senses air pressure in the supply (emergency) line. If air pressure in the supply line is lost, the trailer air supply valve will close automatically, and the resulting loss of air pressure in the tractor protection valve will cause it to close as well. And loss of pressure in the supply line will cause the trailer emergency (spring) brakes to come on.

Not quite. The answer is It will keep dirt and water out of the lines.

Some vehicles are equipped with "dead-end" or dummy couplers. When the air lines are not connected to a trailer, connect the glad hands to the dummy couplers to keep water and dirt out of the glad hands and air lines. If your vehicle doesn't have dummy couplers, you may be able to connect the glad hands to each other.

Not quite. The answer is Normal

To test the trailer air brake system, first charge it with air. Push in the red trailer air supply knob, or place the tractor protection valve control in the "normal" position. Wait until the air pressure reaches normal before you start your tests.

Not quite. The answer is your brakes might fail.

On a combination vehicle, the brakes on the tractor and all trailers must work properly. If your combination vehicle is equipped with air brakes, check that air flows to all trailers and test both the trailer service brakes and the trailer emergency brakes.

Not quite. The answer is release the brakes.

Once you realize your vehicle is in a skid, you should release the brakes so that the wheels can grip the road again. The trailer will start to follow the tractor and straighten out.

Not quite. The answer is supply air to the trailer system and then pull out the air supply knob.

Before you back under the trailer, you must lock the trailer brakes. First, supply air to the trailer air brake system and make sure that the system is working properly. Then set the trailer air supply control to lock the trailer brakes. To do this, pull out the red air supply knob (on newer vehicles) or move the tractor protection valve control to the emergency setting.

Not quite. The answer is A 3-axle tractor towing two 27-foot trailers

When any vehicle turns, its rear wheels will follow a shorter path than its front wheels. This is called off-tracking or "cheating." The longer the vehicle, the greater the difference. In a combination vehicle, the trailer's wheels will off-track more than the tractor's rear wheels. In a double or triple combination vehicle, the wheels of the last trailer will off-track the most.

Not quite. The answer is opening the emergency line shut-off valve and then the service line valve at the rear of the last trailer and listening for air escaping each time.

To check whether air is flowing to all trailers, go to the rear of the last trailer and open the emergency line shut-off valve there. If the entire system is charged, you should hear air escaping. Then close that valve and open the service line valve. Again, you should hear air escaping.

Not quite. The answer is To prevent steering problems

There shouldn't be any space between the upper and lower fifth wheel. However, friction could cause steering problems. To reduce friction, make sure that the fifth wheel plate is well lubricated as required.

Not quite. The answer is the tractor protection valve control (trailer air supply control) will pop out or go from "normal" to "emergency."

When you test the tractor protection valve, the tractor protection valve control (also called the trailer air supply control) should pop out or go from the "normal" to the "emergency" position. This shows that the tractor protection valve has closed automatically to keep the air pressure from falling too far.

Not quite. The answer is at normal pressure.

Before backing under a trailer during the coupling process, make sure that the air pressure is at normal levels so you'll be able to brake safely.

Not quite. The answer is Drive normally and get it fixed later.

Losing the ABS function does not change the basic parts of your truck, so you will still have the same brakes that you have always had. Simply use them and get the ABS repaired as soon as possible. There is no need to panic, unless your system shows other and more serious warnings.