Maryland CDL: Combination Vehicles Practice Test

Not quite. The answer is hang it with the plug down.

After you disconnect the electrical cable, hang it with the plug down to keep moisture or rain from getting into it.

Not quite. The answer is a fully loaded trailer

Trucks brake best when they are used as they were designed: to carry a properly balanced load. Empty trucks actually have longer stopping distances than loaded trucks because they have less traction. The stiff suspension springs and strong brakes give poor traction and make it easier to lock the wheels.

Not quite. The answer is None

If there is space between the lower and upper fifth wheel after you have finished coupling, something is wrong. Perhaps the kingpin is on top of the closed fifth-wheel jaws, which could result in the trailer coming loose. Don't start to drive until you have identified and fixed the problem.

Not quite. The answer is the trailer brakes are locked.

During coupling, before backing under the trailer, set the trailer air supply control to shut off the air and lock the trailer brakes. On newer vehicles, this control is an eight-sided red knob. You pull it out to shut off the air.

Not quite. The answer is opening the emergency line shut-off valve and then the service line valve at the rear of the last trailer and listening for air escaping each time.

To check whether air is flowing to all trailers, go to the rear of the last trailer and open the emergency line shut-off valve there. If the entire system is charged, you should hear air escaping. Then close that valve and open the service line valve. Again, you should hear air escaping.

Not quite. The answer is A triple 27-foot trailer

Because of rearward amplification (causing the crack-the-whip effect), the last trailer in a combination vehicle has the highest probability of rolling over. The last trailer in a triple combination is more likely to roll over than the last trailer in a double combination.

Not quite. The answer is at normal pressure.

Before backing under a trailer during the coupling process, make sure that the air pressure is at normal levels so you'll be able to brake safely.

Not quite. The answer is the coupling is not right and should be fixed before you drive the coupled unit.

Don't drive the vehicle until you're sure that the coupling is correct. Check to make sure of the following: There is no space between the upper and lower fifth wheel, the fifth wheel jaws have closed around the shank of the kingpin, the locking lever is in the "lock" position, and the safety latch is in position over the locking lever. If anything isn't right, don't drive the vehicle until you've found and corrected the problem. If you drive it anyway, your trailer could come loose while you're driving.

Not quite. The answer is turn the crank a few more times to lift some weight off the tractor.

After the landing gear has made firm contact with the ground, turn the crank in low gear a few more times to take some weight off the tractor, but not so much that you lift the trailer off the fifth wheel. This will make it easier to unlatch the fifth wheel and couple the trailer the next time.

Not quite. The answer is The shank

Don't drive the vehicle until you're sure that the coupling is correct. Check to make sure of the following: There is no space between the upper and lower fifth wheel, the fifth wheel jaws have closed around the shank of the kingpin, the locking lever is in the "lock" position, and the safety latch is in position over the locking lever. If anything isn't right, don't drive the vehicle until you've found and corrected the problem. If you drive it anyway, your trailer could come loose while you're driving.

Not quite. The answer is the coupling surface of the trailer is just below the middle of the tractor fifth wheel.

The tractor fifth wheel should tilt downward toward the trailer. As you start to back the tractor under the trailer, the coupling surface of the trailer should be just below the middle of the tractor fifth wheel.

Not quite. The answer is If you make a quick lane change or sudden movement of your steering wheel, your trailers will tend to swing out. The rearmost trailer will swing out the most and will be most likely to roll over.

A sudden maneuver by the tractor may cause the rearmost (last) trailer to swing violently and possibly roll over. This is known as the crack-the-whip effect. It is caused by rearward amplification: The farther a trailer is from the tractor, the more likely it is to start swinging dangerously out of control.

Not quite. The answer is more

There are more things to inspect on a combination vehicle than on a bus or straight truck. First, of course, there is the entire coupling system: the kingpin, the fifth wheel, etc. Next, there is the landing gear of each trailer. Finally, the air brake system is also more complicated than on a bus or straight truck, because compressed air must flow to all trailers so that both the tractor brakes and trailer brakes will work properly.

Not quite. The answer is Drive normally and get it fixed later.

Losing the ABS function does not change the basic parts of your truck, so you will still have the same brakes that you have always had. Simply use them and get the ABS repaired as soon as possible. There is no need to panic, unless your system shows other and more serious warnings.

Not quite. The answer is Control line and signal line

The service air line is also known as the control line or signal line.

Not quite. The answer is Turn wide as you complete your turn.

To turn right, you may need to turn wide to help prevent the rear end of your vehicle from overrunning the curb. However, if you swing wide to the left before you turn right, another driver may try to pass you on your right, which can lead to a collision. Instead, start the right turn with the rear of your vehicle as close to the curb as possible and then turn wide as you complete the turn. This will deny drivers room on the right to try to pass you.

Not quite. The answer is ten times as likely to roll over in a crash as empty rigs.

When you stack cargo high in a trailer, you raise its center of gravity, which makes the trailer more prone to rolling over. A fully loaded tractor-trailer is ten times as likely to roll over in a crash as an empty one.

Not quite. The answer is always use the lowest reverse gear.

When coupling, use the lowest reverse gear and back slowly to avoid hitting or damaging the kingpin.

Not quite. The answer is supply air to the trailer system and then pull out the air supply knob.

Before backing under the trailer, check that the trailer brakes are working and then lock the trailer brakes. Once you've attached the air lines, there are a number of checks you should make: Check the glad hand seals. Make sure that the air lines won't be caught or crushed when you back under the trailer. Charge the trailer air brake system and verify that it's working without significant air loss. Then set the trailer air supply control to shut off the air and put on the trailer emergency brakes.

Not quite. The answer is to the driver's side.

If you must back your vehicle on a curved path, back toward the driver's side. You'll be able to watch the rear of your vehicle from your driver's-side window.