Georgia CDL: Double & Triple Trailers Practice Test

Not quite. The answer is 5

In this context, articulation or pivoting means movement between two units separated by a joint, such as between a tractor and a trailer. A triple combination has 3 semitrailers connected with 2 converter dollies. This combination has 5 points of articulation: (1) the fifth wheel of the tractor; (2) the pintle hook of the first trailer; (3) the fifth wheel of the first converter dolly; (4) the pintle hook of the second trailer; and (5) the fifth wheel of the second converter dolly.

Not quite. The answer is slightly raised.

When connecting the rear trailer to the converter dolly, lock the trailer brakes and raise the trailer landing gear slightly off the ground so it won't be damaged if the trailer moves. Then pull forward with the trailer brakes still locked, to check that the rear trailer is locked onto the converter dolly. If it's not, at least the landing gear will keep the rear trailer from falling onto the ground.

Not quite. The answer is use controlled or stab braking.

Hard braking and turning at the same time is likely to cause a skid. You should brake in a way that will keep your vehicle in a straight line and allow you to turn if necessary. If you need to brake suddenly to avoid a crash, use controlled braking or stab braking (but don't use stab braking if your vehicle has antilock brakes).

Not quite. The answer is Check for normal air pressure. Release the parking brakes. Pull forward slowly. Apply the trailer brakes, using the hand control if so equipped.

Checking your trailer's service brakes is a four-step process: 1. Check for normal air pressure. 2. Release the parking brakes. 3. Pull your vehicle forward slowly. 4. Apply the trailer brakes, using the hand control (trolley valve) if so equipped. If the trailer brakes are properly connected and working, you should feel them come on at this point.

Not quite. The answer is rear.

Vehicles with double or triple trailers can experience a dangerous "crack-the-whip" effect, caused by rearward amplification. If you make a quick lane change, the crack-the-whip effect can turn the trailers over. (There have been many accidents where only the trailer overturned.) Rearward amplification is strongest at the rearmost trailer. Therefore, position your heaviest trailer at the front and your lightest trailer at the rear.

Not quite. The answer is slightly raised.

To test the coupling of the dolly to the second trailer, you'll pull the tractor forward so the dolly will pull against the kingpin of the second trailer. Before doing so, raise the trailer's landing gear slightly. This will prevent damage if the trailer moves, and prevent the trailer from falling onto the ground if the dolly pulls away from the trailer.

Not quite. The answer is There are more critical parts to check.

There is nothing inherently wrong with double or triple trailers. There are just more critical parts to check. For a triple, you must check the critical parts of three trailers and two converter dollies, problems in any of which can cause serious trouble.

Not quite. The answer is Closed

A pre-trip inspection of a double or triple combination vehicle includes an inspection of each converter dolly. Among other things, check that the converter dolly air tank petcock is closed.

Not quite. The answer is foot pedal.

The trailer hand valve (also called the Trolley Valve or Johnson Bar) operates only the trailer brakes, not the tractor brakes. Hence, use it only when you want to test the trailer brakes. Don't use it in normal driving because braking the trailers and not the tractor can cause a trailer to skid. The foot brake sends air to all the brakes on the vehicle – the tractor and all trailers. There is much less danger of causing a skid or jackknife when using just the foot brake.

Not quite. The answer is air escape from the open valve.

Test the trailer brakes by opening the service line valve at the rear of the rig. You should hear the telltale hiss of air escaping. If you don't, it means that air is not flowing through the entire line, and you will need to investigate.

Not quite. The answer is foot pedal.

You can use the trailer hand valve (also known as a spike or Johnson bar) to test the trailer service brakes. During normal driving, however, all the service brakes on your vehicle are controlled with the foot pedal, which applies air to the service brakes at all the wheels.

Not quite. The answer is that you can pull straight through.

When parking a long vehicle, you should look for a parking space that you can go straight through rather than back out of. Also note the layout of the parking lot and your parking space's location within it so you won't have difficulty exiting the parking space later.

Not quite. The answer is How the rear wheels follow a different path from the front wheels in a turn

Off-tracking is defined as the different paths taken by the front and rear wheels in a turn. The longer the vehicle, the greater the difference will be. As a result, the path followed by a tractor will be wider than the path of the rig itself. To compensate, you must steer the tractor wider to keep the rig from overrunning the curb or hitting some object.

Not quite. The answer is Never

Older vehicles may be equipped with manual front-wheel limiting valves. A control in the cab allows the driver to cut air pressure to the front brakes in half. It was thought that doing this would help reduce front-wheel skids on slippery roads. According to the CDL manual, however, more recent tests have shown that front-wheel braking is safe even on icy roads. Federal regulations now prohibit manual front-wheel limiting valves in vehicles manufactured since March 1, 1975. Automatic ratio valves, which limit front-axle braking only when brake applications are approximately 60 psi or less, are still permitted. These valves cannot be controlled manually by the driver. Note: The advent of antilock brakes (ABS) may make automatic ratio valves less useful as well.

Source: 49 CFR § 393.48

Not quite. The answer is only the more common types of combinations.

The official CDL manual's section on double and triple trailers usually describes how to couple and uncouple the more common types of double and triple combinations. However, there are other ways of coupling and uncoupling the many types of truck-trailer and tractor-trailer combinations that are in use. To learn how to couple and uncouple the vehicles you will be driving, consult the manufacturer's or owner's specifications.

Not quite. The answer is If there are vehicles on both sides of you, a move to the right may still be best.

To avoid a head-on collision, steer right toward the shoulder or curbline. Even if you are blocked on both sides by other vehicles, a move to the right may still be best. At least you won't force other drivers into an opposing traffic lane, possibly involving them in a head-on collision. Prepare to drive entirely off the roadway to the right if necessary to avoid a head-on collision. Head-on collisions are often fatal.

Not quite. The answer is You must drive a double or triple very smoothly to avoid a rollover or jackknife.

Take special care when pulling two or three trailers. Doubles and triples are more likely to turn over than other combination vehicles because of the "crack-the-whip" effect. You must steer gently when pulling trailers. To prevent the trailers from rolling over, you must steer gently and go slowly around corners, on-ramps, off-ramps, and curves.

Not quite. The answer is using the dolly's parking brake control.

To connect the converter dolly to the first semitrailer, release the dolly's brakes so it can be moved. You release the dolly's brakes by opening the air tank petcock (valve) or using the dolly's parking brake control if the dolly is equipped with spring brakes.

Not quite. The answer is may be too fast for a set of doubles or triples.

On curves, doubles and triples are more likely to roll over than other combination vehicles. A safe speed on a curve for a straight truck or a single-trailer combination vehicle may be too fast for a set of doubles or triples. To prevent trailers from rolling over, you must steer gently and go slowly around corners, on-ramps, off-ramps, and curves.

Not quite. The answer is a separate air tank.

Federal regulations require brakes on every wheel of a combination vehicle, including the wheels of the semitrailers and converter dollies. Like semitrailers, dollies have their own air brakes and their own air tanks.

Source: 49 CFR § 393.42