Florida CDL: Combination Vehicles Practice Test

Not quite. The answer is trailer emergency brakes to come on.

With the loss of air pressure, the tractor protection valve will close and the trailer emergency brakes will come on.

Not quite. The answer is at normal pressure.

Before backing under a trailer during the coupling process, make sure that the air pressure is at normal levels so you'll be able to brake safely.

Not quite. The answer is You should turn wide as you complete the turn.

To turn right, you must turn wide to help prevent the rear end from overrunning the curb. However, if you start the right turn by swinging wide to the left, another driver may try to pass you on your right while you are turning, which can lead to a collision. Instead, start the right turn with the rear of your vehicle as close to the curb as possible and then turn wide as you complete the turn. This will deny drivers room on the right to try to pass you.

Not quite. The answer is the emergency and service air lines.

Before backing under the trailer, you must lock the trailer brakes – which means that you first have to make sure that the trailer brakes are working. Connect the emergency and service air lines and test the trailer brakes.

Not quite. The answer is The trailer emergency brakes will come on.

The trailer air supply valve (which is manually controlled by the red dashboard knob) senses air pressure in the supply (emergency) line. If air pressure in the supply line is lost, the trailer air supply valve will close automatically, and the resulting loss of air pressure in the tractor protection valve will cause it to close as well. And loss of pressure in the supply line will cause the trailer emergency (spring) brakes to come on.

Not quite. The answer is A tractor pulling three trailers

The last trailer of a triple is 3.5 times more likely to roll over than a five-axle tractor. This is known as the crack-the-whip effect. When pulling a triple, increase your following distance, avoid sudden moves, and steer gently. At night, don't drive faster than your headlight range.

Not quite. The answer is By pushing it in, you supply the trailer with air.

On newer vehicles, the trailer air supply control is an eight-sided red knob. You push it in to supply the trailer with air, and you pull it out to shut the air off and put on the trailer emergency brakes.

Not quite. The answer is see it in your mirrors.

The earliest way to notice that your trailer is jackknifing is to see it swinging out in your mirrors.

Not quite. The answer is No, because the brakes on the trailer wheels caused the skid to begin with.

The trailer skid was caused by the brakes locking the wheels. Applying the trailer hand brake might make that even worse. Instead, release the brakes so the trailer wheels can roll again and regain traction.

Not quite. The answer is makes firm contact with the ground.

When uncoupling a loaded trailer, lower the landing gear until it makes firm contact with the ground. Then crank the landing gear in low gear for a few more turns – just enough to lift some weight off the tractor, but not so much that you lift the trailer off the fifth wheel. This will make it easier to unlatch the fifth wheel now and couple next time.

Not quite. The answer is to the driver's side.

If you must back your vehicle on a curved path, back toward the driver's side. You'll be able to watch the rear of your vehicle from your driver's-side window.

Not quite. The answer is All the way up

Raise the landing gear completely to keep it from getting caught on railroad tracks or something along the roadway.

Not quite. The answer is (a) The tractor is on level ground.

When coupling a trailer to a tractor, it's a good idea to make sure that you're on a level surface free of dips or potholes. If you back the tractor over a large bump, dip, or pothole, you might damage something as you attempt to push the tractor underneath the trailer. On the other hand, the trailer itself need not be perfectly level. You want it to be aligned so that it will be raised slightly when the tractor is backed underneath it.

Not quite. The answer is slightly raised.

After you've backed under the trailer and locked the kingpin into the fifth wheel, raise the landing gear slightly. Then with the trailer brakes still locked, gently pull the tractor forward to check that the trailer is locked onto the tractor.

Not quite. The answer is Neutral

Before you inspect the trailer supports of the landing gear, secure the tractor by applying the parking brake and placing the transmission in Neutral.

Not quite. The answer is secured but with enough slack for turns.

During your walk-around inspection, make sure that the electrical and air lines are secure but have enough slack to stay attached and secure even when the vehicle is turning.

Not quite. The answer is All of the above

The two types of combination vehicles most likely to get stuck at a raised railroad crossing are low-slung units (car carriers, lowboys, moving vans, etc.) and single-axle tractors that are pulling a long trailer with its landing gear set for a tandem-axle tractor. Be very careful when driving such vehicles at railroad crossings.

Not quite. The answer is A 5-axle tractor towing a 52-foot trailer

When any vehicle turns, its rear wheels will follow a shorter path than its front wheels. This is called off-tracking or "cheating." The longer the vehicle, the greater the difference. In a combination vehicle, the trailer's wheels will off-track more than the tractor's rear wheels. In a double or triple combination vehicle, the wheels of the last trailer will off-track the most.

Not quite. The answer is keep the cargo as low as possible and drive slowly around turns.

More than half of truck driver deaths in accidents are the result of truck rollovers. The higher the truck's center of gravity, the more likely it is to roll over. If the cargo is to one side, it will make the trailer lean, which can also make a rollover more likely. To help prevent a rollover, keep your cargo centered and as low as possible, and drive slowly around turns.

Not quite. The answer is To engage the trailer brakes in case of air pressure loss

The emergency air line has two main functions: (1) It supplies air to the trailer air tanks to keep the trailer brake system charged. (2) It controls the vehicle's emergency brakes. If air pressure in the emergency air line drops too low (say because of a bad leak or damage due to the trailer breaking loose), the trailer emergency brakes will come on. Also, the tractor protection valve will close to keep air from escaping from the tractor.