Arkansas CDL: Double & Triple Trailers Practice Test

Not quite. The answer is Turnpike double trailer

A double pup trailer consists of two 28.5-foot trailers, known as "pup trailers." A double pup trailer is also known as an STAA trailer, named for the Surface Transportation Assistance Act (STAA). This is the only type of double trailer that is allowed nationwide. A Rocky Mountain double trailer consists of a 40- to 53-foot trailer followed by a 28.5-foot pup trailer. Rocky Mountain doubles are allowed in certain Western states. A turnpike double trailer consists of two 48-foot trailers. Turnpike doubles can be found traveling on expressways in the Eastern states.

Not quite. The answer is Uncouple the third semitrailer from the second dolly.

To couple a triple-trailer combination, you couple the tractor and first semitrailer to the second and third semitrailers. But to uncouple the triple-trailer combination, you start by just uncoupling the third semitrailer from the rest of the combination.

Not quite. The answer is Use the engine brake or speed retarder.

A retarder supplements the braking force on the drive wheels. On a slippery surface, this may cause the wheels to lock, resulting in a skid. Turn off your retarder when driving on wet, icy, or snowy roads. Instead, slow down, increase your following distance, and try to brake gently.

Not quite. The answer is foot pedal.

You can use the trailer hand valve (also known as a spike or Johnson bar) to test the trailer service brakes. During normal driving, however, all the service brakes on your vehicle are controlled with the foot pedal, which applies air to the service brakes at all the wheels.

Not quite. The answer is the vehicle is more likely to roll over or jackknife.

A double or triple combination vehicle is more likely to roll over or jackknife from sudden braking or steering changes. Look far enough ahead that you can slow down or change lanes gradually when necessary.

Not quite. The answer is do both of the above.

In bad weather or mountain driving or on slippery roads, use extreme caution. When you drive a double or triple, you're pulling a lot of dead axles with just a few drive axles. This increases the chance of loss of traction, causing a skid. Also, rearward amplification makes the rearmost trailer much more prone to rolling over. Drive slowly around curves and turns and avoid sudden moves.

Not quite. The answer is 20 to 45 psi.

The tractor protection valve keeps air in the tractor or truck brake system should the trailer break away or develop a bad leak. The tractor protection valve is designed to close automatically when the air pressure falls into the range specified by the manufacturer, typically 20–45 psi.

Not quite. The answer is the trailer will be raised slightly when the converter dolly is backed under it.

To connect the rear trailer to the converter dolly, the trailer must be at the right height. It should be slightly lower than the center of the dolly's fifth wheel so that the trailer will be raised slightly when the dolly is pushed underneath it.

Not quite. The answer is Go to the rear of the second trailer and open the emergency line shut-off valve.

To check whether air is being supplied to the second trailer, go to the rear of the trailer and open the emergency line shut-off valve. You should hear air escaping, indicating that the entire system is charged up to that point. (For a triple combination vehicle, perform this procedure with the third trailer.)

Not quite. The answer is 10

The formula for following distance is one second per ten feet of vehicle length, plus an extra second if you are traveling over 40 mph. Therefore, for a 100-foot vehicle traveling at 30 mph, you should leave a following distance of 100/10 = 10 seconds. (At or below 40 mph, you do not add an extra second.)

Not quite. The answer is You must drive a double or triple very smoothly to avoid a rollover or jackknife.

Take special care when pulling two or three trailers. Doubles and triples are more likely to turn over than other combination vehicles because of the "crack-the-whip" effect. You must steer gently when pulling trailers. To prevent the trailers from rolling over, you must steer gently and go slowly around corners, on-ramps, off-ramps, and curves.

Not quite. The answer is Never

Older vehicles may be equipped with manual front-wheel limiting valves. A control in the cab allows the driver to cut air pressure to the front brakes in half. It was thought that doing this would help reduce front-wheel skids on slippery roads. According to the CDL manual, however, more recent tests have shown that front-wheel braking is safe even on icy roads. Federal regulations now prohibit manual front-wheel limiting valves in vehicles manufactured since March 1, 1975. Automatic ratio valves, which limit front-axle braking only when brake applications are approximately 60 psi or less, are still permitted. These valves cannot be controlled manually by the driver. Note: The advent of antilock brakes (ABS) may make automatic ratio valves less useful as well.

Source: 49 CFR § 393.48

Not quite. The answer is drive through quickly.

If you drive through water at higher speeds, your tires may lose their grip of the road and start to skid. When driving through water, slow down and shift into a low gear. Increase engine rpm and apply the brakes gently to keep the brake linings pressed against the brake drums or discs. This will help keep contaminants out of the brakes.

Not quite. The answer is Either (a) or (b)

Federal regulation 49 CFR 380.205 states that you must meet various requirements before you can start training to operate a triple long combination vehicle. These requirements include 6 months' immediately prior experience driving either a tractor/semi-trailer combination or a tractor/semi-trailer/trailer combination, with a gross combination weight rating (GCWR) of at least 26,001 pounds.

Not quite. The answer is both of the above are true.

Check each landing gear to be sure that it is fully raised. Also check that no parts are missing and it isn't bent or damaged.

Not quite. The answer is A truck has less traction when it's empty than when it's fully loaded.

Trucks that are empty or only lightly loaded take longer to stop because the stiff suspension springs and strong brakes give poor traction and make it easier to lock the wheels.

Not quite. The answer is park the vehicle in a straight line on firm level ground.

To uncouple the rear trailer, the first thing you do is park the vehicle in a straight line on firm level ground. Apply the parking brakes to keep the vehicle from moving. If the second trailer doesn't have spring brakes, chock its wheels.

Not quite. The answer is apply light pressure on the brakes.

Avoid driving through deep puddles or flowing water if possible. If not, slow down and downshift into a low gear. Gently press on the brakes and maintain pressure for a short distance when you are out of the water. This will heat up the brakes and dry them out. (However, don't overdo it, or the brakes may overheat.) Then apply the brakes to make a test stop when it is safe to do so.

Not quite. The answer is 3

In this context, articulation or pivoting means movement between two units separated by a joint, such as between a tractor and a trailer. The standard or STAA double combination in the CDL handbook has 3 points of articulation: (1) the fifth wheel of the tractor; (2) the pintle hook of the front trailer; (3) the fifth wheel of the converter dolly.

Not quite. The answer is Some do; some don't.

All converter dollies built since 1975 are required to have spring brakes. Older converter dollies that don't have spring brakes have emergency air brakes, which work from the air stored in the trailer air tank.