Washington CDL: Tanker Vehicles Practice Test

Not quite. The answer is Spring brakes (or wheel chocks)

When parking a tank trailer, you should always apply the parking brake. On a modern trailer equipped with air brakes, applying the parking brake control will exhaust air from the brake chambers and cause the spring brakes to come on. However, an old trailer may lack spring brakes and instead use compressed air to set the parking brakes. In this case, you must chock the wheels to prevent the trailer from moving. A leak somewhere in the air braking system may cause the parking brakes to fail eventually.

Not quite. The answer is Inspect the vehicle.

Before loading, unloading, or driving a tanker, you must inspect the vehicle. This makes sure that the vehicle is safe to carry liquids or gases and is safe to drive. Tank vehicles have special items that you need to check. Study the vehicle's operator manual to learn how to inspect your tank vehicle.

Not quite. The answer is can affect the handling of your vehicle.

Liquid surge can greatly affect your vehicle's handling. Surge can push the vehicle in the same direction as the surge. This can be especially hazardous on icy roads, where a truck may be pushed forward a dangerous amount, maybe past a red light into an intersection. On curves, side-to-side surge can cause a rollover even when traction is good.

Not quite. The answer is distribution of weight.

If the tank is divided into several smaller tanks (compartments) by bulkheads, pay attention to the distribution of weight whenever you load or unload these tanks. Avoid putting too much weight on the front or the back of your vehicle.

Not quite. The answer is Surge can move the truck in the direction the liquid waves move.

One of the reasons you must drive a tanker vehicle carefully is that liquid surge can push the vehicle in the same direction as the surge. This can be especially hazardous on icy roads, where a truck may be pushed forward a dangerous amount, maybe past a red light into an intersection.

Not quite. The answer is Keep a steady foot on the brake and don't release the brake too soon.

To control the effects of surge, brake far in advance of a stop. Maintain steady pressure on the brakes and don't release them too soon.

Not quite. The answer is There will be less front-to-back surge than in a tank without baffles.

A baffled tank has bulkheads with holes through which the liquid can flow forward or backward but with less force than if there were no baffles. This will reduce forward-and-backward surge, making it less likely that surge will push your vehicle forward when you try to stop.

Not quite. The answer is Your brakes may fail because of water freezing.

Your air tanks hold a mixture of water and compressor oil. If left inside to collect at the bottom, the water may freeze and cause brake failure.

Not quite. The answer is 5 mph slower.

On a steep downgrade, don't keep applying your brakes continuously because this might cause them to fade (become less effective). Instead, apply your brakes sparingly as a supplement to engine braking. Select a "safe" speed. Let your vehicle reach this speed. Brake gently until you are going 5 mph slower. Then let your speed increase back to the "safe" speed. Keep varying your speed up and down this way. This technique is known as snub braking or snubbing.

Not quite. The answer is bulkheads with holes that let the liquid flow through.

Baffled tanks have bulkheads with holes through which the liquid can flow but with less force than in a tank without such bulkheads.

Not quite. The answer is MC-306 (DOT-406)

MC-306 (DOT-406) cargo tanks carry liquids under very low or no pressure (maximum allowable pressure of 3 psi for MC-306 and 4 psi for DOT-406). The cargo tank has an oval or elliptical cross section and is usually compartmented. These tanks are commonly used to carry gasoline, diesel fuel or fuel oil, and other flammable liquids.

Not quite. The answer is leaks.

When you inspect your tank vehicle, the most important thing to check for is leaking tanks. It is illegal to knowingly carry liquids or gases in a leaking tank. Check around and underneath the vehicle for any signs of leaks. Also check all tanks, hoses, pipes, and connections for leaks.

Not quite. The answer is individual tanks over 119 gallons or a total of at least 1,000 gallons.

You must have a tank vehicle (N) endorsement to drive a vehicle with one or more individual tanks over 119 gallons or multiple tanks totaling at least 1,000 gallons.

Not quite. The answer is Environment

The S.T.A.M.P.E.D. acronym is widely used to assist you in obtaining the correct hoses and fittings for your needs. S: the required size of the hose; T: the temperatures to which the hose will be subjected; A: the application (use) to which the hose will be put; M: the types of material (liquid, gas, etc.) that will have to flow through the hose; P: the maximum working pressure of the hose; E: the required fittings at the ends of the hose; D: the date at which the hose must be delivered to you.

Not quite. The answer is your vehicle will stay in a straight line.

If you must brake in an emergency, brake in a way that keeps your vehicle in a straight line while still letting you turn if necessary. You can use the "controlled braking" method or (in a vehicle without antilock brakes) the "stab braking" method.

Not quite. The answer is Watch gauges and mirrors and use your senses to check for problems.

During your trip, you should be watching a number of things, such as your mirrors, gauges, instruments, lights, tires, and cargo. Use several of your senses – sight, hearing, smell, and feel – to detect possible trouble.

Not quite. The answer is You should avoid traveling alongside other vehicles whenever possible.

Whenever another vehicle is traveling alongside yours, there's always a chance that the vehicle might try to move into your lane and accidentally hit your vehicle. Also, the vehicle is blocking you from changing lanes. It's safer to find an open spot where there are no vehicles on either side of you. (Of course, that may not be possible in heavy, congested traffic.)

Not quite. The answer is the top of the tank

In general, the Maximum Allowable Working Pressure (MAWP) of a pressurized tank is the maximum pressure that the weakest part of the tank can handle in normal operation. For a cargo tank on a motor vehicle, the federal definition of MAWP assumes that the weakest part is at the top of the tank.

Source: 49 CFR 178.320

Not quite. The answer is surging.

When a tank is not completely filled, the liquid has room to move around. It can slosh back and forth or side to side. This is called surging.

Not quite. The answer is Both of the above are true.

Tank vehicles have a high center of gravity, typically five or six feet above the ground. This makes a tanker top-heavy, which makes it more prone to rollovers than other types of vehicles. Tests have shown that a tank vehicle can roll over at the speed limits posted for curves. To take an upcoming curve safely, slow down well below the posted speed limit.