Vermont CDL: Double & Triple Trailers Practice Test

Not quite. The answer is Lower the second semitrailer's landing gear.

When uncoupling a set of standard doubles, the first unit to be uncoupled is the second semitrailer. To do this, lower its landing gear just enough to take some weight off the dolly. Then close the air shut-off valves on the first semitrailer and on the dolly (if so equipped). Disconnect the dolly's air and electrical lines from the second semitrailer. Release the dolly's fifth wheel latch, and pull the tractor forward so it pulls the dolly out from under the second semitrailer. After this is done, start to uncouple the dolly from the first semitrailer. These steps include lowering the dolly's landing gear and unhooking the dolly from the first semitrailer's pintle latch.

Not quite. The answer is Turnpike double trailer

A double pup trailer consists of two 28.5-foot trailers, known as "pup trailers." A double pup trailer is also known as an STAA trailer, named for the Surface Transportation Assistance Act (STAA). This is the only type of double trailer that is allowed nationwide. A Rocky Mountain double trailer consists of a 40- to 53-foot trailer followed by a 28.5-foot pup trailer. Rocky Mountain doubles are allowed in certain Western states. A turnpike double trailer consists of two 48-foot trailers. Turnpike doubles can be found traveling on expressways in the Eastern states.

Not quite. The answer is open; closed

When you are inspecting a double or triple combination, make sure that the service and emergency line shut-off valves are open at the rear of each trailer except the last trailer, where they must be closed.

Not quite. The answer is Some do; some don't.

All converter dollies built since 1975 are required to have spring brakes. Older converter dollies that don't have spring brakes have emergency air brakes, which work from the air stored in the trailer air tank.

Not quite. The answer is Hook the converter dolly to the front semitrailer.

To couple standard doubles, the first step is to correctly position the dolly in front of the second semitrailer. You can do this by hand or by picking up the dolly with the first semitrailer. Either way, the dolly must be connected to the first semitrailer before proceeding further. Once this is done, back the tractor, first semitrailer, and dolly until you back the dolly underneath the second semitrailer. Only after you've checked and tested the coupling, and connected all the air lines and electrical lines, should you raise the landing gear.

Not quite. The answer is the tractor protection valve control (trailer air supply control) will pop out or go from "normal" to "emergency."

When you test the tractor protection valve, the tractor protection valve control (also called the trailer air supply control) should pop out or go from the "normal" to the "emergency" position. This shows that the tractor protection valve has closed automatically to keep the air pressure from falling too far.

Not quite. The answer is enough to take some of the weight off the dolly.

When uncoupling a loaded second or third semitrailer, lower the landing gear until it makes firm contact with the ground. Then crank the landing gear in low gear for a few more turns – just enough to lift some weight off the dolly, but not so much that you lift the trailer off the fifth wheel. This will make it easier to unlatch the fifth wheel now and couple the trailer next time.

Not quite. The answer is Never

Older vehicles may be equipped with manual front-wheel limiting valves. A control in the cab allows the driver to cut air pressure to the front brakes in half. It was thought that doing this would help reduce front-wheel skids on slippery roads. According to the CDL manual, however, more recent tests have shown that front-wheel braking is safe even on icy roads. Federal regulations now prohibit manual front-wheel limiting valves in vehicles manufactured since March 1, 1975. Automatic ratio valves, which limit front-axle braking only when brake applications are approximately 60 psi or less, are still permitted. These valves cannot be controlled manually by the driver. Note: The advent of antilock brakes (ABS) may make automatic ratio valves less useful as well.

Source: 49 CFR § 393.48

Not quite. The answer is A sudden movement with the steering wheel can result in a tipped-over rear trailer.

Because of rearward amplification (the "crack-the-whip" effect), the rearmost trailer is much more prone to rolling over. Avoid sudden steering changes that could cause the rearmost trailer to roll over.

Not quite. The answer is open the shut-off valves at the rear of the first trailer and close the shut-off valves at the rear of the second trailer.

Air must travel through the air lines of the tractor and all trailers – and that's all. Open the shut-off valves at the rear of each trailer but the last one to enable the air to travel to the trailer behind it. Close the shut-off valves at the rear of the last trailer to keep air from escaping.

Not quite. The answer is the rear trailer of a triple.

In a double or triple combination, each trailer is more likely to roll over than the one in front of it. The rear trailer of a triple is 3.5 times as likely to roll over as a five-axle tractor-trailer. This is known as rearward amplification or the "crack-the-whip effect." For safety, position the heaviest trailer in front and the lightest trailer in the rear.

Not quite. The answer is B.

If you swing wide to the left before you turn right, another vehicle may try to pass you on your right while you are turning. Instead, as shown in path B, make the right turn with the rear of your vehicle as close to the curb as possible and turn wide as you complete the turn. This will deny other vehicles enough room on the right to try to pass you.

Not quite. The answer is 5

In this context, articulation or pivoting means movement between two units separated by a joint, such as between a tractor and a trailer. A triple combination has 3 semitrailers connected with 2 converter dollies. This combination has 5 points of articulation: (1) the fifth wheel of the tractor; (2) the pintle hook of the first trailer; (3) the fifth wheel of the first converter dolly; (4) the pintle hook of the second trailer; and (5) the fifth wheel of the second converter dolly.

Not quite. The answer is pull against the pin of the second trailer.

Test the coupling by pulling against the pin of the second semitrailer.

Not quite. The answer is Use wheel chocks.

If the second trailer doesn’t have spring brakes, drive the tractor close to the trailer, connect the emergency line, charge the trailer air tank, and disconnect the emergency line. This will set the trailer emergency brakes (assuming the slack adjusters are correctly adjusted). However, if you have any doubt about the effectiveness of the trailer's braking system, chock the wheels.

Not quite. The answer is may be too fast for a set of doubles or triples.

On curves, doubles and triples are more likely to roll over than other combination vehicles. A safe speed on a curve for a straight truck or a single-trailer combination vehicle may be too fast for a set of doubles or triples. To prevent trailers from rolling over, you must steer gently and go slowly around corners, on-ramps, off-ramps, and curves.

Not quite. The answer is both of the above are true.

Check each landing gear to be sure that it is fully raised. Also check that no parts are missing and it isn't bent or damaged.

Not quite. The answer is the shut-off valves, the converter dolly or dollies, and the air brakes on all trailers.

To inspect a double or triple, first inspect it just as you would inspect any combination vehicle. Then check that the shut-off valves are open on all trailers but the last trailer. Check each converter dolly to be sure that the pintle hook is properly latched.

Not quite. The answer is There should be none.

When the rear trailer is properly coupled to the converter dolly, there should be no space between the upper and lower fifth wheel. (Similarly, when the front trailer is properly coupled to the tractor, there should be no space between the upper and lower fifth wheel either.) If there is visible space, something is wrong. Don't drive the vehicle until you have corrected the problem because the trailer might come loose.

Not quite. The answer is The heaviest trailer

The rearmost trailer is much more likely to roll over than the front trailer. Position the heaviest trailer directly behind the tractor and position the lightest trailer at the rear.