New Jersey CDL: Combination Vehicles Practice Test

Not quite. The answer is secured but with enough slack for turns.

During your walk-around inspection, make sure that the electrical and air lines are secure but have enough slack to stay attached and secure even when the vehicle is turning.

Not quite. The answer is It takes 14 seconds to clear a single track and more than 15 seconds to clear a double track.

You can expect it to take more than 15 seconds for a typical tractor-trailer to clear a double track and at least 14 seconds to clear a single track.

Not quite. The answer is to test the trailer brakes.

The trailer hand valve (also known as a trolley valve or Johnson bar) controls only the trailer brakes, not the tractor brakes. You can use it to test the trailer brakes. Don't use it while you're driving, though. If you apply it while you're driving, you'll brake the trailers but not the tractor, which can cause a skid. Instead, use the foot brake, which sends air to the tractor brakes as well as the trailer brakes.

Not quite. The answer is All the way up

Raise the landing gear completely so it won't catch on railroad tracks or something else on the roadway.

Not quite. The answer is emergency line

The trailer air supply valve (which is manually controlled by the red dashboard knob) senses air pressure in the supply (emergency) line. If air pressure in the supply line is lost, the trailer air supply valve will close automatically, and the resulting loss of air pressure in the tractor protection valve will cause it to close as well. And loss of pressure in the supply line will cause the trailer emergency (spring) brakes to come on.

Not quite. The answer is often do not have spring brakes.

Trailers and converter dollies built before 1975 are not required to have spring brakes. Instead, they rely on emergency brakes that hold using air pressure. Because air pressure can leak away, always use wheel chocks when parking such vehicles.

Not quite. The answer is You should turn wide as you complete the turn.

To turn right, you must turn wide to help prevent the rear end from overrunning the curb. However, if you start the right turn by swinging wide to the left, another driver may try to pass you on your right while you are turning, which can lead to a collision. Instead, start the right turn with the rear of your vehicle as close to the curb as possible and then turn wide as you complete the turn. This will deny drivers room on the right to try to pass you.

Not quite. The answer is emergency

The tractor protection valve keeps air in the tractor if the trailer breaks away or develops a bad leak. If air pressure drops too low in the service line, the tractor protection valve will close. This stops air from escaping from the tractor and lets air out of the trailer emergency line, causing the trailer emergency brakes to come on.

Not quite. The answer is The rear wheels of the last trailer

Off-tracking is defined as the different paths taken by the front and rear wheels in a turn. The longer the vehicle, the greater the difference will be. Thus, the wheels on the front trailer will offtrack more than the tractor's rear wheels, and the wheels on the rearmost trailer will offtrack most of all.

Not quite. The answer is 90 degrees

When connecting the glad hands, press the two seals together with the couplers at a 90-degree angle to each other. A turn of the glad hand attached to the hose will join and lock the couplers.

Not quite. The answer is keep the cargo as low as possible and drive slowly around turns.

More than half of truck driver deaths in accidents are the result of truck rollovers. The higher the truck's center of gravity, the more likely it is to roll over. If the cargo is to one side, it will make the trailer lean, which can also make a rollover more likely. To help prevent a rollover, keep your cargo centered and as low as possible, and drive slowly around turns.

Not quite. The answer is "Bobtail" tractors can take longer to stop than a combination vehicle loaded to the maximum gross weight.

When a combination vehicle is empty or lightly loaded, its braking distance increases. The very stiff suspension springs and strong brakes give poor traction and make it very easy to lock the wheels. Likewise, "bobtail" tractors (tractors without semitrailers) can take longer to stop than a fully loaded tractor-trailer. Be very careful when driving a "bobtail" tractor.

Not quite. The answer is Look under the vehicle for the ECU and wheel speed sensor wires coming from the back of the brakes.

You can tell if your vehicle has ABS by looking under the vehicle for the electronic control unit (ECU) and wheel speed sensor wires leading from the back of the brakes.

Not quite. The answer is see it in your mirrors.

The earliest way to notice that your trailer is jackknifing is to see it swinging out in your mirrors.

Not quite. The answer is Control line and signal line

The service air line is also known as the control line or signal line.

Not quite. The answer is None

If there is space between the lower and upper fifth wheel after you have finished coupling, something is wrong. Perhaps the kingpin is on top of the closed fifth-wheel jaws, which could result in the trailer coming loose. Don't start to drive until you have identified and fixed the problem.

Not quite. The answer is If the trailer has no spring brakes, you will be able to drive away but you won't have trailer brakes.

Trailers built before 1975 are not required to have spring brakes. If you cross the air lines when coupling such a trailer, you may have no air pressure to supply the trailer brakes. You'll be able to drive, but you won't be able to brake the trailer. Always test the trailer air brakes before you start to drive.

Not quite. The answer is step on and off the brake pedal several times.

To test the tractor protection valve, charge the trailer air brake system, turn off the engine, and lower the air pressure by stepping on and off the brake pedal several times. The tractor protection valve control (also called the trailer air supply control) should pop out (or go from the “normal” to the “emergency” position) when the air pressure falls into the range specified by the manufacturer (typically 20–45 psi).

Not quite. The answer is 20 to 45 psi.

The tractor protection valve keeps air in the tractor or truck brake system should the trailer break away or develop a bad leak. The tractor protection valve is designed to close automatically when the air pressure falls into the range specified by the manufacturer, typically 20–45 psi.

Not quite. The answer is the trailer's emergency brakes to come on.

The trailer air supply valve (which is manually controlled by the red dashboard knob) senses air pressure in the supply (emergency) line. If air pressure in the supply line is lost, the trailer air supply valve will close automatically, and the resulting loss of air pressure in the tractor protection valve will cause it to close as well. And loss of pressure in the supply line will cause the trailer emergency (spring) brakes to come on.