Mississippi CDL: Combination Vehicles Practice Test

Not quite. The answer is tilted down toward the rear of the tractor.

Before coupling, make sure that the fifth wheel is in the proper position. For one thing, it should be tilted down toward the rear of the tractor so that the trailer can easily slide into it.

Not quite. The answer is Gently pull forward in low gear against the locked trailer brakes; then look at it carefully.

After you've backed under the trailer and locked the kingpin into the fifth wheel, raise the landing gear slightly. Then with the trailer brakes still locked, gently pull the tractor forward to check that the trailer is locked onto the tractor.

Not quite. The answer is to test the trailer brakes.

The trailer hand valve (also known as a trolley valve or Johnson bar) controls only the trailer brakes, not the tractor brakes. You can use it to test the trailer brakes. Don't use it while you're driving, though. If you apply it while you're driving, you'll brake the trailers but not the tractor, which can cause a skid. Instead, use the foot brake, which sends air to the tractor brakes as well as the trailer brakes.

Not quite. The answer is slightly raised.

After you've backed under the trailer and locked the kingpin into the fifth wheel, raise the landing gear slightly. Then with the trailer brakes still locked, gently pull the tractor forward to check that the trailer is locked onto the tractor.

Not quite. The answer is a Class A CDL with a Doubles/Triples (T) endorsement.

To legally pull a trailer whose gross vehicle weight rating (GVWR) exceeds 10,000 pounds, you'll have to obtain a Class A CDL. To pull triples, you'll also have to obtain a Doubles/Triples (T) endorsement on your CDL. Note: If you don't also pass a knowledge test on air brakes, your Mississippi CDL will include restriction K, limiting you to driving only vehicles without air brakes.

Not quite. The answer is Fully raised with the crank handle secured in its bracket

Once you've coupled, raise the landing gear all the way up. If it's only partially raised, it could catch on something, such as the railroad tracks on a raised railroad crossing.

Not quite. The answer is A triple 27-foot trailer

Because of rearward amplification (causing the crack-the-whip effect), the last trailer in a combination vehicle has the highest probability of rolling over. The last trailer in a triple combination is more likely to roll over than the last trailer in a double combination.

Not quite. The answer is emergency line

The trailer air supply valve (which is manually controlled by the red dashboard knob) senses air pressure in the supply (emergency) line. If air pressure in the supply line is lost, the trailer air supply valve will close automatically, and the resulting loss of air pressure in the tractor protection valve will cause it to close as well. And loss of pressure in the supply line will cause the trailer emergency (spring) brakes to come on.

Not quite. The answer is Drive normally and get it fixed later.

Losing the ABS function does not change the basic parts of your truck, so you will still have the same brakes that you have always had. Simply use them and get the ABS repaired as soon as possible. There is no need to panic, unless your system shows other and more serious warnings.

Not quite. The answer is over the locking lever.

The safety latch should be in position over the fifth wheel locking lever. On some vehicles, you may have to position it manually.

Not quite. The answer is The rear trailer is twice as likely to turn over as the tractor.

Because of rearward amplification, the last trailer on a combination vehicle has the highest probability of rolling over. This is called the crack-the-whip effect.

Not quite. The answer is pushing in the trailer air supply control.

On newer vehicles, the trailer air supply control is an eight-sided red knob on the dashboard of the tractor. The knob may be labeled "Pull to exhaust...Push to supply" or something similar. When you push the knob in, air will flow through the trailer's emergency air lines to charge the trailer air brake system.

Not quite. The answer is always use the lowest reverse gear.

When coupling, use the lowest reverse gear and back slowly to avoid hitting or damaging the kingpin.

Not quite. The answer is A 3-axle tractor towing two 27-foot trailers

When any vehicle turns, its rear wheels will follow a shorter path than its front wheels. This is called off-tracking or "cheating." The longer the vehicle, the greater the difference. In a combination vehicle, the trailer's wheels will off-track more than the tractor's rear wheels. In a double or triple combination vehicle, the wheels of the last trailer will off-track the most.

Not quite. The answer is The trailer emergency brakes will come on.

If the emergency (supply) air line breaks, the tractor protection valve will close to stop any more compressed air from leaving the tractor. Hence, the tractor's service brakes should still work. However, the loss of trailer air pressure from the ruptured line will cause the trailer emergency (spring) brakes to come on.

Not quite. The answer is the brakes will fail if the air supply leaks away.

If the trailer lacks spring brakes, make sure you chock the wheels whenever you park. If air pressure leaks away, the trailer's brakes will fail. Without chocks, the trailer could roll away.

Not quite. The answer is the trailer emergency glad hand.

During the coupling process, after you've backed the tractor till it's touching the trailer and you've parked the tractor, it's time to connect the air lines. Connect the tractor emergency air line to the trailer emergency glad hand. Connect the tractor service air line to the trailer service glad hand.

Not quite. The answer is the tractor protection valve to close.

The tractor protection valve keeps air in the tractor if the trailer breaks away or develops a bad leak. If air pressure drops too low in the service line, the tractor protection valve will close. This stops air from escaping from the tractor and lets air out of the trailer emergency line, causing the trailer emergency brakes to come on.

Not quite. The answer is secured but with enough slack for turns.

During your walk-around inspection, make sure that the electrical and air lines are secure but have enough slack to stay attached and secure even when the vehicle is turning.

Not quite. The answer is The trailer emergency brakes will come on.

The trailer air supply valve (which is manually controlled by the red dashboard knob) senses air pressure in the supply (emergency) line. If air pressure in the supply line is lost, the trailer air supply valve will close automatically, and the resulting loss of air pressure in the tractor protection valve will cause it to close as well. And loss of pressure in the supply line will cause the trailer emergency (spring) brakes to come on.