Maine CDL: Double & Triple Trailers Practice Test

Not quite. The answer is step on and off the brake pedal several times.

To test the tractor protection valve, charge the trailer air brake system, turn off the engine, and lower the air pressure by stepping on and off the brake pedal several times. The tractor protection valve control (also called the trailer air supply control) should pop out (or go from the “normal” to the “emergency” position) when the air pressure falls into the range specified by the manufacturer (typically 20–45 psi).

Not quite. The answer is use controlled or stab braking.

Hard braking and turning at the same time is likely to cause a skid. You should brake in a way that will keep your vehicle in a straight line and allow you to turn if necessary. If you need to brake suddenly to avoid a crash, use controlled braking or stab braking (but don't use stab braking if your vehicle has antilock brakes).

Not quite. The answer is do both of the above.

In bad weather or mountain driving or on slippery roads, use extreme caution. When you drive a double or triple, you're pulling a lot of dead axles with just a few drive axles. This increases the chance of loss of traction, causing a skid. Also, rearward amplification makes the rearmost trailer much more prone to rolling over. Drive slowly around curves and turns and avoid sudden moves.

Not quite. The answer is slightly raised.

When connecting the rear trailer to the converter dolly, lock the trailer brakes and raise the trailer landing gear slightly off the ground so it won't be damaged if the trailer moves. Then pull forward with the trailer brakes still locked, to check that the rear trailer is locked onto the converter dolly. If it's not, at least the landing gear will keep the rear trailer from falling onto the ground.

Not quite. The answer is Brake and downshift in the curve.

Before entering a curve, slow down to a safe speed and downshift into the right gear. This lets you use some power through the curve to help keep the vehicle stable through the curve. It also allows you to speed up as soon as you are out of the curve.

Not quite. The answer is more likely to turn over.

In a double or triple combination, each trailer is more likely to roll over than the one in front of it. The rear trailer of a triple is 3.5 times as likely to roll over as a five-axle tractor-trailer. This is known as the "crack-the-whip" effect, caused by rearward amplification. For safety, position the heaviest trailer in front and the lightest trailer in the rear.

Not quite. The answer is Doubles/triples flip over from quick steering movements more easily than do many other vehicles.

Because of rearward amplification (the "crack-the-whip" effect), steering changes affect the rearmost trailer much more than they affect the front trailer or the tractor. Avoid quick or sharp steering changes that could cause the rearmost trailer to roll over.

Not quite. The answer is Neither of the above will cause it.

Despite what footnote 5 in 49 CFR 393.11 says, Operational Policy 15 of the North American Standard Out-of-Service Criteria states that a converter dolly must have one stop lamp, one tail lamp, and (if the dolly obscures the tractor's rear turn signals) turn signal lights, but only when the dolly is being towed singly and is not towing a trailer. In a full multi-trailer configuration, the rearmost trailer must have working stop lights and taillights, of course.

Not quite. The answer is using the dolly's parking brake control.

To connect the converter dolly to the first semitrailer, release the dolly's brakes so it can be moved. You release the dolly's brakes by opening the air tank petcock (valve) or using the dolly's parking brake control if the dolly is equipped with spring brakes.

Not quite. The answer is Check your mirrors to keep an eye on your tires.

Use the mirrors to keep an eye on your tires. It's one way to spot a tire fire. But your mirrors don't eliminate all blind spots. Your truck still has large blind spots, often called No-Zones.

Not quite. The answer is A sudden movement with the steering wheel can result in a tipped-over rear trailer.

Because of rearward amplification (the "crack-the-whip" effect), the rearmost trailer is much more prone to rolling over. Avoid sudden steering changes that could cause the rearmost trailer to roll over.

Not quite. The answer is Turnpike double trailer

A double pup trailer consists of two 28.5-foot trailers, known as "pup trailers." A double pup trailer is also known as an STAA trailer, named for the Surface Transportation Assistance Act (STAA). This is the only type of double trailer that is allowed nationwide. A Rocky Mountain double trailer consists of a 40- to 53-foot trailer followed by a 28.5-foot pup trailer. Rocky Mountain doubles are allowed in certain Western states. A turnpike double trailer consists of two 48-foot trailers. Turnpike doubles can be found traveling on expressways in the Eastern states.

Not quite. The answer is Allow a greater following distance than for smaller commercial vehicles.

Doubles and triples need more space because they can’t be turned or stopped suddenly. Allow a greater following distance behind the vehicle in front of you.

Not quite. The answer is the shut-off valves, the converter dolly or dollies, and the air brakes on all trailers.

To inspect a double or triple, first inspect it just as you would inspect any combination vehicle. Then check that the shut-off valves are open on all trailers but the last trailer. Check each converter dolly to be sure that the pintle hook is properly latched.

Not quite. The answer is Older models may lack spring brakes.

All converter dollies built since 1975 are required to have spring brakes. All converter dollies built since 1998 are required to have antilock brakes as well.

Not quite. The answer is One second for every ten feet of your vehicle

The usual formula for following distance under ideal conditions is one second for every ten feet of vehicle length, plus an extra second if you are traveling at over 40 mph.

Not quite. The answer is Use wheel chocks.

If the second trailer doesn’t have spring brakes, drive the tractor close to the trailer, connect the emergency line, charge the trailer air tank, and disconnect the emergency line. This will set the trailer emergency brakes (assuming the slack adjusters are correctly adjusted). However, if you have any doubt about the effectiveness of the trailer's braking system, chock the wheels.

Not quite. The answer is both of the above are true.

Check each landing gear to be sure that it is fully raised. Also check that no parts are missing and it isn't bent or damaged.

Not quite. The answer is sometimes lack antilock brakes.

All trailers and converter dollies built since March 1, 1998 are required to have antilock brakes (ABS).

Not quite. The answer is Go to the rear of the second trailer and open the emergency line shut-off valve.

To check whether air is being supplied to the second trailer, go to the rear of the trailer and open the emergency line shut-off valve. You should hear air escaping, indicating that the entire system is charged up to that point. (For a triple combination vehicle, perform this procedure with the third trailer.)