Kansas CDL: Double & Triple Trailers Practice Test

Not quite. The answer is Use wheel chocks.

If the second trailer doesn’t have spring brakes, drive the tractor close to the trailer, connect the emergency line, charge the trailer air tank, and disconnect the emergency line. This will set the trailer emergency brakes (assuming the slack adjusters are correctly adjusted). However, if you have any doubt about the effectiveness of the trailer's braking system, chock the wheels.

Not quite. The answer is Never

Older vehicles may be equipped with manual front-wheel limiting valves. A control in the cab allows the driver to cut air pressure to the front brakes in half. It was thought that doing this would help reduce front-wheel skids on slippery roads. According to the CDL manual, however, more recent tests have shown that front-wheel braking is safe even on icy roads. Federal regulations now prohibit manual front-wheel limiting valves in vehicles manufactured since March 1, 1975. Automatic ratio valves, which limit front-axle braking only when brake applications are approximately 60 psi or less, are still permitted. These valves cannot be controlled manually by the driver. Note: The advent of antilock brakes (ABS) may make automatic ratio valves less useful as well.

Source: 49 CFR § 393.48

Not quite. The answer is the tractor protection valve control (trailer air supply control) will pop out or go from "normal" to "emergency."

When you test the tractor protection valve, the tractor protection valve control (also called the trailer air supply control) should pop out or go from the "normal" to the "emergency" position. This shows that the tractor protection valve has closed automatically to keep the air pressure from falling too far.

Not quite. The answer is Rocky Mountain double

A double pup trailer consists of two 28.5-foot trailers, known as "pup trailers." A double pup trailer is also known as an STAA trailer, named for the Surface Transportation Assistance Act (STAA). This standard-double configuration is the only type of double trailer that is allowed nationwide. A Rocky Mountain double trailer consists of a 40- to 53-foot trailer followed by a 28.5-foot pup trailer. Rocky Mountain doubles are allowed in certain Western states. A turnpike double trailer consists of two 48-foot trailers. Turnpike doubles can be found traveling on expressways in the Eastern states.

Not quite. The answer is air escape from the open valve.

Test the trailer brakes by opening the service line valve at the rear of the rig. You should hear the telltale hiss of air escaping. If you don't, it means that air is not flowing through the entire line, and you will need to investigate.

Not quite. The answer is a coupling device that connects a semitrailer to the rear of a tractor-trailer.

The converter dolly connects a semitrailer to the rear of a tractor-trailer, forming a double or triple combination.

Not quite. The answer is You need about four times as much braking distance at 40 mph as at 20 mph.

Your total stopping distance is the sum of your perception distance (how far your vehicle goes from when you see the hazard until your brain processes it), reaction distance (how far the vehicle goes from when your brain orders your foot to take action until your foot actually starts to brake), and braking distance (how far the vehicle continues to travel once you apply the brake). Your vehicle's braking distance increases as the square of your speed. For example, you need about four times as much braking distance at 40 mph as you do at 20 mph.

Not quite. The answer is the vehicle is more likely to roll over or jackknife.

A double or triple combination vehicle is more likely to roll over or jackknife from sudden braking or steering changes. Look far enough ahead that you can slow down or change lanes gradually when necessary.

Not quite. The answer is Charge the trailer's air tank and then disconnect the emergency air line.

If the second trailer doesn’t have spring brakes, drive the tractor close to the trailer, connect the emergency line, charge the trailer air tank, and disconnect the emergency air line. This will set the trailer emergency brakes (assuming the slack adjusters are correctly adjusted). Chock the wheels if you have any doubt about the brakes.

Not quite. The answer is closed.

To uncouple the second trailer, start by applying the parking brakes to keep your vehicle from moving. Lower the landing gear of the second trailer. Close the shut-off valves at the rear of the first trailer (and on the dolly if so equipped) to keep air from going out of the vehicle. Then disconnect the dolly air and electric lines, release the dolly brakes, and release the dolly fifth wheel latch. You are now ready to pull the first trailer and the dolly away from the second trailer.

Not quite. The answer is 20 to 45 psi.

The tractor protection valve keeps air in the tractor or truck brake system should the trailer break away or develop a bad leak. The tractor protection valve is designed to close automatically when the air pressure falls into the range specified by the manufacturer, typically 20–45 psi.

Not quite. The answer is either of the above, if available.

You can secure the second trailer with either the spring brakes or the emergency air line. For an extra margin of safety, chock the wheels too.

Not quite. The answer is Check your mirrors to keep an eye on your tires.

Use the mirrors to keep an eye on your tires. It's one way to spot a tire fire. But your mirrors don't eliminate all blind spots. Your truck still has large blind spots, often called No-Zones.

Not quite. The answer is Either (a) or (b)

Federal regulation 49 CFR 380.205 states that you must meet various requirements before you can start training to operate a triple long combination vehicle. These requirements include 6 months' immediately prior experience driving either a tractor/semi-trailer combination or a tractor/semi-trailer/trailer combination, with a gross combination weight rating (GCWR) of at least 26,001 pounds.

Not quite. The answer is park the vehicle in a straight line on firm level ground.

To uncouple the rear trailer, the first thing you do is park the vehicle in a straight line on firm level ground. Apply the parking brakes to keep the vehicle from moving. If the second trailer doesn't have spring brakes, chock its wheels.

Not quite. The answer is Overloaded front axles can make the steering axle weight too light to steer safely.

Underloaded front axles (caused by shifting weight too far to the rear) can make the steering axle weight too light to steer safely.

Not quite. The answer is The more sharply you turn, the greater the chances of a skid or rollover.

Don't turn any more than needed to clear whatever is in your way. The more sharply you turn, the greater the chances of a skid or rollover.

Not quite. The answer is Brake and downshift in the curve.

Before entering a curve, slow down to a safe speed and downshift into the right gear. This lets you use some power through the curve to help keep the vehicle stable through the curve. It also allows you to speed up as soon as you are out of the curve.

Not quite. The answer is enough to take some of the weight off the dolly.

When uncoupling a loaded second or third semitrailer, lower the landing gear until it makes firm contact with the ground. Then crank the landing gear in low gear for a few more turns – just enough to lift some weight off the dolly, but not so much that you lift the trailer off the fifth wheel. This will make it easier to unlatch the fifth wheel now and couple the trailer next time.

Not quite. The answer is leaks of air or hydraulic fluid

Check the landing gear as part of your walk-around inspection. Check that no parts are missing and it isn't bent or damaged. If the landing gear is power operated, check its hoses, fittings, and other parts for signs or sounds of escaping air or hydraulic fluid.