Idaho CDL: Double & Triple Trailers Practice Test

Not quite. The answer is March 1998.

Antilock brakes have been required on all tractors built since March 1, 1997. Antilock brakes have been required on all trailers, converter dollies, buses, and single trucks built since March 1, 1998.

Not quite. The answer is A sudden movement with the steering wheel can result in a tipped-over rear trailer.

Because of rearward amplification (the "crack-the-whip" effect), the rearmost trailer is much more prone to rolling over. Avoid sudden steering changes that could cause the rearmost trailer to roll over.

Not quite. The answer is you couple the third trailer to the second trailer before you couple them to the first trailer.

A triple combination vehicle has four units (not counting the converter dollies): a tractor and three trailers. You couple a triple as follows: 1. Couple the first trailer to the tractor the same way that you couple any combination vehicle. 2. Couple the third trailer to the second trailer using the method for coupling doubles (which will involve the use of a converter dolly). 3. Move another converter dolly into position. 4. Couple the tractor and first trailer to the second and third trailer using the method for coupling doubles (which will involve another converter dolly).

Not quite. The answer is open; closed

When you are inspecting a double or triple combination, make sure that the service and emergency line shut-off valves are open at the rear of each trailer except the last trailer, where they must be closed.

Not quite. The answer is Pull against the rear semitrailer's pin.

To check the coupling of the rear semitrailer, pull against the pin holding the rear semitrailer. Never move your vehicle until you are sure that all trailers are properly coupled.

Not quite. The answer is rear.

Vehicles with double or triple trailers can experience a dangerous "crack-the-whip" effect, caused by rearward amplification. If you make a quick lane change, the crack-the-whip effect can turn the trailers over. (There have been many accidents where only the trailer overturned.) Rearward amplification is strongest at the rearmost trailer. Therefore, position your heaviest trailer at the front and your lightest trailer at the rear.

Not quite. The answer is may be too fast for a set of doubles or triples.

On curves, doubles and triples are more likely to roll over than other combination vehicles. A safe speed on a curve for a straight truck or a single-trailer combination vehicle may be too fast for a set of doubles or triples. To prevent trailers from rolling over, you must steer gently and go slowly around corners, on-ramps, off-ramps, and curves.

Not quite. The answer is Rocky Mountain double

A double pup trailer consists of two 28.5-foot trailers, known as "pup trailers." A double pup trailer is also known as an STAA trailer, named for the Surface Transportation Assistance Act (STAA). This standard-double configuration is the only type of double trailer that is allowed nationwide. A Rocky Mountain double trailer consists of a 40- to 53-foot trailer followed by a 28.5-foot pup trailer. Rocky Mountain doubles are allowed in certain Western states. A turnpike double trailer consists of two 48-foot trailers. Turnpike doubles can be found traveling on expressways in the Eastern states.

Not quite. The answer is the shut-off valves, the converter dolly or dollies, and the air brakes on all trailers.

To inspect a double or triple, first inspect it just as you would inspect any combination vehicle. Then check that the shut-off valves are open on all trailers but the last trailer. Check each converter dolly to be sure that the pintle hook is properly latched.

Not quite. The answer is pull against the pin of the second trailer.

Test the coupling by pulling against the pin of the second semitrailer.

Not quite. The answer is supply air to the trailer air brake system with the tractor and then disconnect the emergency line.

If the second trailer lacks spring brakes, set the emergency brakes or chock the wheels.

Not quite. The answer is apply light pressure on the brakes.

Avoid driving through deep puddles or flowing water if possible. If not, slow down and downshift into a low gear. Gently press on the brakes and maintain pressure for a short distance when you are out of the water. This will heat up the brakes and dry them out. (However, don't overdo it, or the brakes may overheat.) Then apply the brakes to make a test stop when it is safe to do so.

Not quite. The answer is Allow a greater following distance than for smaller commercial vehicles.

Doubles and triples need more space because they can’t be turned or stopped suddenly. Allow a greater following distance behind the vehicle in front of you.

Not quite. The answer is Older models may lack spring brakes.

All converter dollies built since 1975 are required to have spring brakes. All converter dollies built since 1998 are required to have antilock brakes as well.

Not quite. The answer is drive through quickly.

If you drive through water at higher speeds, your tires may lose their grip of the road and start to skid. When driving through water, slow down and shift into a low gear. Increase engine rpm and apply the brakes gently to keep the brake linings pressed against the brake drums or discs. This will help keep contaminants out of the brakes.

Not quite. The answer is Lower the second semitrailer's landing gear.

When uncoupling a set of standard doubles, the first unit to be uncoupled is the second semitrailer. To do this, lower its landing gear just enough to take some weight off the dolly. Then close the air shut-off valves on the first semitrailer and on the dolly (if so equipped). Disconnect the dolly's air and electrical lines from the second semitrailer. Release the dolly's fifth wheel latch, and pull the tractor forward so it pulls the dolly out from under the second semitrailer. After this is done, start to uncouple the dolly from the first semitrailer. These steps include lowering the dolly's landing gear and unhooking the dolly from the first semitrailer's pintle latch.

Not quite. The answer is the vehicle is more likely to roll over or jackknife.

A double or triple combination vehicle is more likely to roll over or jackknife from sudden braking or steering changes. Look far enough ahead that you can slow down or change lanes gradually when necessary.

Not quite. The answer is that you can pull straight through.

When parking a long vehicle, you should look for a parking space that you can go straight through rather than back out of. Also note the layout of the parking lot and your parking space's location within it so you won't have difficulty exiting the parking space later.

Not quite. The answer is to lower its landing gear.

After you have uncoupled the rear trailer from the converter dolly, you need to uncouple the converter dolly from the front trailer. You do this as follows: 1. Lower the landing gear of the dolly. 2. Disconnect the safety chains. 3. Apply the dolly's spring brakes or chock its wheels to keep the dolly from moving. 4. Release the pintle hook connecting the dolly to the trailer ahead of it. 5. Slowly pull clear of the dolly.

Not quite. The answer is Use the engine brake or speed retarder.

A retarder supplements the braking force on the drive wheels. On a slippery surface, this may cause the wheels to lock, resulting in a skid. Turn off your retarder when driving on wet, icy, or snowy roads. Instead, slow down, increase your following distance, and try to brake gently.