Delaware CDL: Double & Triple Trailers Practice Test

Not quite. The answer is the rear trailer of a triple.

In a double or triple combination, each trailer is more likely to roll over than the one in front of it. The rear trailer of a triple is 3.5 times as likely to roll over as a five-axle tractor-trailer. This is known as rearward amplification or the "crack-the-whip effect." For safety, position the heaviest trailer in front and the lightest trailer in the rear.

Not quite. The answer is a coupling device that connects a semitrailer to the rear of a tractor-trailer.

The converter dolly connects a semitrailer to the rear of a tractor-trailer, forming a double or triple combination.

Not quite. The answer is more likely to turn over.

In a double or triple combination, each trailer is more likely to roll over than the one in front of it. The rear trailer of a triple is 3.5 times as likely to roll over as a five-axle tractor-trailer. This is known as the "crack-the-whip" effect, caused by rearward amplification. For safety, position the heaviest trailer in front and the lightest trailer in the rear.

Not quite. The answer is Allow much more space than is needed under ideal driving conditions.

The usual formula for following distance under ideal conditions is one second for every ten feet of vehicle length, plus an extra second if you are traveling at over 40 mph. The only thing the CDL manual says about following distance on slippery roads is that you should allow "much more space to stop." The Federal Motor Carrier Safety Administration (FMCSA) recommends doubling your usual following distance under poor driving conditions.

Source: "CMV Driving Tips - Following Too Closely," FMCSA, https://www.fmcsa.dot.gov/safety/driver-safety/cmv-driving-tips-following-too-closely

Not quite. The answer is 2

In this context, articulation or pivoting means movement between two units separated by a joint, such as between a tractor and a trailer. The standard or STAA doubles described in your official state CDL handbook are connected with an A-dolly, which has a single drawbar connected to the front trailer. However, a B-double (also called a B-train double) has a two-drawbar B-dolly (or C-dolly), which is connected to two hitches in the front trailer. The two drawbar connections prevent this type of dolly from pivoting on the front trailer. The rear trailer connects to the dolly's fifth wheel. Hence, the only two pivot points are the tractor's fifth wheel and the B-dolly's fifth wheel. B-trains are legal in parts of Michigan and Washington State.

Not quite. The answer is If there are vehicles on both sides of you, a move to the right may still be best.

To avoid a head-on collision, steer right toward the shoulder or curbline. Even if you are blocked on both sides by other vehicles, a move to the right may still be best. At least you won't force other drivers into an opposing traffic lane, possibly involving them in a head-on collision. Prepare to drive entirely off the roadway to the right if necessary to avoid a head-on collision. Head-on collisions are often fatal.

Not quite. The answer is only the more common types of combinations.

The official CDL manual's section on double and triple trailers usually describes how to couple and uncouple the more common types of double and triple combinations. However, there are other ways of coupling and uncoupling the many types of truck-trailer and tractor-trailer combinations that are in use. To learn how to couple and uncouple the vehicles you will be driving, consult the manufacturer's or owner's specifications.

Not quite. The answer is enough to take some of the weight off the dolly.

When uncoupling a loaded second or third semitrailer, lower the landing gear until it makes firm contact with the ground. Then crank the landing gear in low gear for a few more turns – just enough to lift some weight off the dolly, but not so much that you lift the trailer off the fifth wheel. This will make it easier to unlatch the fifth wheel now and couple the trailer next time.

Not quite. The answer is Charge the trailer's air tank and then disconnect the emergency air line.

If the second trailer doesn’t have spring brakes, drive the tractor close to the trailer, connect the emergency line, charge the trailer air tank, and disconnect the emergency air line. This will set the trailer emergency brakes (assuming the slack adjusters are correctly adjusted). Chock the wheels if you have any doubt about the brakes.

Not quite. The answer is 11

The formula for following distance is one second per ten feet of vehicle length, plus an extra second if you are traveling over 40 mph. Therefore, for a 100-foot vehicle traveling at 50 mph, you should leave a following distance of 100/10 + 1 = 11 seconds.

Not quite. The answer is An additional drawbar

The type of converter dolly described in your official state CDL manual is an A-dolly. It has a single drawbar, whose eye fits over the pintle hook in the rear of a semitrailer. The A-dolly can pivot or articulate on that pintle hook. In contrast, a B-dolly (or C-dolly) has two drawbars, each with its own eye. These fit over two pintle hooks in the rear of a trailer. These two connections prevent the B-dolly from pivoting on the pintle hooks, thus eliminating one articulation or pivot point. B-dollies are used to connect B-doubles (also called B-train doubles).

Not quite. The answer is The pintle eye of the dolly should be in place in the pintle hook of the trailer.

A pre-trip inspection of a double or triple combination vehicle includes an inspection of each converter dolly in the vehicle. Among other things, check the coupling of the dolly to the trailer in front. Make sure that the pintle eye of the dolly is in place in the pintle hook of the trailer, and the pintle hook is latched closed.

Not quite. The answer is You need about four times as much braking distance at 40 mph as at 20 mph.

Your total stopping distance is the sum of your perception distance (how far your vehicle goes from when you see the hazard until your brain processes it), reaction distance (how far the vehicle goes from when your brain orders your foot to take action until your foot actually starts to brake), and braking distance (how far the vehicle continues to travel once you apply the brake). Your vehicle's braking distance increases as the square of your speed. For example, you need about four times as much braking distance at 40 mph as you do at 20 mph.

Not quite. The answer is supply air to the trailer air brake system with the tractor and then disconnect the emergency line.

If the second trailer lacks spring brakes, set the emergency brakes or chock the wheels.

Not quite. The answer is directly in front of the converter dolly.

Back the first trailer into position in front of the tongue of the dolly. Hook the dolly to the pintle hook on the first trailer. Then latch the pintle hook securely. Raise the dolly's landing gear.

Not quite. The answer is Both (a) and (b)

Take special care when pulling two or three trailers. In bad weather, under slippery conditions, and in mountain driving, you must be especially careful. There is a greater risk of skids and loss of traction. Also, doubles and triples need more space because they can’t be turned or stopped suddenly. Maintain a greater following distance. Make sure you have large enough gaps before entering or crossing traffic.

Not quite. The answer is the shut-off valves, the converter dolly or dollies, and the air brakes on all trailers.

To inspect a double or triple, first inspect it just as you would inspect any combination vehicle. Then check that the shut-off valves are open on all trailers but the last trailer. Check each converter dolly to be sure that the pintle hook is properly latched.

Not quite. The answer is that you can pull straight through.

When parking a long vehicle, you should look for a parking space that you can go straight through rather than back out of. Also note the layout of the parking lot and your parking space's location within it so you won't have difficulty exiting the parking space later.

Not quite. The answer is foot pedal.

The trailer hand valve (also called the Trolley Valve or Johnson Bar) operates only the trailer brakes, not the tractor brakes. Hence, use it only when you want to test the trailer brakes. Don't use it in normal driving because braking the trailers and not the tractor can cause a trailer to skid. The foot brake sends air to all the brakes on the vehicle – the tractor and all trailers. There is much less danger of causing a skid or jackknife when using just the foot brake.

Not quite. The answer is closed; latched

When you do a walk-around inspection, you must ensure that the converter dolly is properly connected to the front trailer. Check that the pintle hook of the front trailer is locked onto the eye hook of the converter dolly and properly latched. Otherwise, the dolly could come loose. Even worse, if the dolly comes loose while it's still coupled to the rear trailer, the tow bar could fly up, possibly injuring someone.