Delaware CDL: Combination Vehicles Practice Test

Not quite. The answer is It controls the emergency brakes on combination vehicles.

The emergency air line is often colored red. It supplies air to the trailer air tanks and controls the emergency brakes on combination vehicles.

Not quite. The answer is "Bobtail" tractors can take longer to stop than fully loaded tractor-trailers.

When a combination vehicle is empty or lightly loaded, its braking distance increases. The very stiff suspension springs and strong brakes give poor traction and make it very easy to lock the wheels. Likewise, "bobtail" tractors (tractors without semitrailers) can take longer to stop than a fully loaded tractor-trailer. Be very careful when driving a "bobtail" tractor.

Not quite. The answer is emergency line

The trailer air supply valve (which is manually controlled by the red dashboard knob) senses air pressure in the supply (emergency) line. If air pressure in the supply line is lost, the trailer air supply valve will close automatically, and the resulting loss of air pressure in the tractor protection valve will cause it to close as well. And loss of pressure in the supply line will cause the trailer emergency (spring) brakes to come on.

Not quite. The answer is the tractor protection valve control (trailer air supply control) will pop out or go from "normal" to "emergency."

When you test the tractor protection valve, the tractor protection valve control (also called the trailer air supply control) should pop out or go from the "normal" to the "emergency" position. This shows that the tractor protection valve has closed automatically to keep the air pressure from falling too far.

Not quite. The answer is Adjust the air supply knob to send air to the trailer brakes. Turn off the engine once the air pressure normalizes. Then listen for the sound of escaping air as the brakes are released.

After coupling, make sure that the air lines are not crossed. To do this, send air to the trailer brakes by adjusting the "air supply" knob to normal. Let the pressure normalize. Then turn off the engine and test the brakes. You should see and hear the brakes in action and then see the air pressure normalize again.

Not quite. The answer is the brakes will fail if the air supply leaks away.

If the trailer lacks spring brakes, make sure you chock the wheels whenever you park. If air pressure leaks away, the trailer's brakes will fail. Without chocks, the trailer could roll away.

Not quite. The answer is Look under the vehicle for the ECU and wheel speed sensor wires coming from the back of the brakes.

You can tell if your vehicle has ABS by looking under the vehicle for the electronic control unit (ECU) and wheel speed sensor wires leading from the back of the brakes.

Not quite. The answer is supply air to the trailer system and then pull out the air supply knob.

Before you back under the trailer, you must lock the trailer brakes. First, supply air to the trailer air brake system and make sure that the system is working properly. Then set the trailer air supply control to lock the trailer brakes. To do this, pull out the red air supply knob (on newer vehicles) or move the tractor protection valve control to the emergency setting.

Not quite. The answer is ten times as likely to roll over in a crash as empty rigs.

When you stack cargo high in a trailer, you raise its center of gravity, which makes the trailer more prone to rolling over. A fully loaded tractor-trailer is ten times as likely to roll over in a crash as an empty one.

Not quite. The answer is 4 psi per minute.

After the initial drop, the maximum acceptable leakage rates with the service brakes on are 3 psi per minute for single vehicles and 4 psi per minute for combination vehicles. If the leakage rate is higher, check for leaks and correct them.

Not quite. The answer is to test the trailer brakes.

The trailer hand valve (also known as a trolley valve or Johnson bar) controls only the trailer brakes, not the tractor brakes. You can use it to test the trailer brakes. Don't use it while you're driving, though. If you apply it while you're driving, you'll brake the trailers but not the tractor, which can cause a skid. Instead, use the foot brake, which sends air to the tractor brakes as well as the trailer brakes.

Not quite. The answer is step on and off the brake pedal several times.

To test the tractor protection valve, charge the trailer air brake system, turn off the engine, and lower the air pressure by stepping on and off the brake pedal several times. The tractor protection valve control (also called the trailer air supply control) should pop out (or go from the “normal” to the “emergency” position) when the air pressure falls into the range specified by the manufacturer (typically 20–45 psi).

Not quite. The answer is slightly raised.

After you've backed under the trailer and locked the kingpin into the fifth wheel, raise the landing gear slightly. Then with the trailer brakes still locked, gently pull the tractor forward to check that the trailer is locked onto the tractor.

Not quite. The answer is Rear

The shut-off valve should be closed only at the rear of the last trailer so that air will flow to the brakes of all trailers but no farther.

Not quite. The answer is it will be raised slightly when the tractor is backed under it.

Before backing the tractor under the trailer, adjust the landing gear to position the trailer at the proper height. The trailer should be just low enough that it will be raised slightly by the tractor when the tractor backs under it. If the trailer is too low, the tractor may hit and damage the trailer nose; if it's too high, it may not couple properly.

Not quite. The answer is low gear.

Start to raise the landing gear by using the low gear range (if the landing gear is so equipped). Then switch to the high gear range once the trailer supports are free of weight.

Not quite. The answer is It will keep dirt and water out of the lines.

Some vehicles are equipped with "dead-end" or dummy couplers. When the air lines are not connected to a trailer, connect the glad hands to the dummy couplers to keep water and dirt out of the glad hands and air lines. If your vehicle doesn't have dummy couplers, you may be able to connect the glad hands to each other.

Not quite. The answer is red; blue

To keep the air lines from being mismatched, they can be labeled with metal tags or color coded. Blue is used for the service lines, and red is used for the emergency lines. Couple the air lines of the same color.

Not quite. The answer is they are more likely to get stuck on raised railroad crossings.

The two types of combination vehicles most likely to get stuck at a raised railroad crossing are low-slung units (car carriers, lowboys, moving vans, etc.) and single-axle tractors that are pulling a long trailer with its landing gear set to accommodate a tandem-axle tractor. Be very careful when driving such vehicles at railroad crossings.

Not quite. The answer is Bobtail tractors can take longer to stop than fully loaded combination vehicles.

When a combination vehicle is empty or lightly loaded, its braking distance increases. The very stiff suspension springs and strong brakes give poor traction and make it very easy to lock the wheels. Likewise, "bobtail" tractors (tractors without semitrailers) can take longer to stop than a fully loaded tractor-trailer. Be very careful when driving a "bobtail" tractor.