Nebraska CDL: Combination Vehicles Practice Test

Not quite. The answer is a Class A CDL with a Doubles/Triples (T) endorsement.

To legally pull a trailer whose gross vehicle weight rating (GVWR) exceeds 10,000 pounds, you'll have to obtain a Class A CDL. To pull triples, you'll also have to obtain a Doubles/Triples (T) endorsement on your CDL. Note: If you don't also pass a knowledge test on air brakes, your Nebraska CDL will include restriction L, limiting you to driving only vehicles without air brakes.

Not quite. The answer is empty.

The weight of a full load adds traction. An empty or lightly loaded trailer is more likely to jackknife than a fully loaded one.

Not quite. The answer is emergency

To test the tractor protection valve, shut the engine off and step on and off the brake pedal several times to reduce the air pressure in the tanks. When the air pressure has fallen enough (typically into the range 20–45 psi), the trailer air supply control knob should pop out, or the valve control should go from the “normal” to the “emergency” position.

Not quite. The answer is the tractor protection valve control (trailer air supply control) will pop out or go from "normal" to "emergency."

When you test the tractor protection valve, the tractor protection valve control (also called the trailer air supply control) should pop out or go from the "normal" to the "emergency" position. This shows that the tractor protection valve has closed automatically to keep the air pressure from falling too far.

Not quite. The answer is check the air line connections.

If you cross the emergency and service air lines, air will flow to the service line instead of the trailer air tanks. Air won't be available to release the spring brakes. Therefore, if the spring brakes don't release when you push the trailer air supply control, check the air line connections.

Not quite. The answer is Fully raised with the crank handle secured in its bracket

Once you've coupled, raise the landing gear all the way up. If it's only partially raised, it could catch on something, such as the railroad tracks on a raised railroad crossing.

Not quite. The answer is step on and off the brake pedal several times.

To test the tractor protection valve, charge the trailer air brake system, turn off the engine, and lower the air pressure by stepping on and off the brake pedal several times. The tractor protection valve control (also called the trailer air supply control) should pop out (or go from the “normal” to the “emergency” position) when the air pressure falls into the range specified by the manufacturer (typically 20–45 psi).

Not quite. The answer is trailer emergency brakes to come on.

If air pressure in the emergency air line drops too low (say because of a bad leak in the service line), the trailer emergency brakes will come on. Also, the tractor protection valve will close to keep air from escaping from the tractor.

Not quite. The answer is Always

If there is a leak in the emergency air line, air will eventually leak out of the trailer air tank. If the trailer has air brakes but not spring brakes, the brakes will fail. Use chocks to prevent the trailer from rolling if its brakes fail.

Not quite. The answer is turn the crank a few more times to lift some weight off the tractor.

After the landing gear has made firm contact with the ground, turn the crank in low gear a few more times to take some weight off the tractor, but not so much that you lift the trailer off the fifth wheel. This will make it easier to unlatch the fifth wheel and couple the trailer the next time.

Not quite. The answer is the trailer brakes are locked.

During coupling, before backing under the trailer, set the trailer air supply control to shut off the air and lock the trailer brakes. On newer vehicles, this control is an eight-sided red knob. You pull it out to shut off the air.

Not quite. The answer is use controlled or stab braking.

Hard braking and turning at the same time is likely to cause a skid. You should brake in a way that will keep your vehicle in a straight line and allow you to turn if necessary. If you need to brake suddenly to avoid a crash, use controlled braking or stab braking (but don't use stab braking if your vehicle has antilock brakes).

Not quite. The answer is A tractor pulling three trailers

The last trailer of a triple is 3.5 times more likely to roll over than a five-axle tractor. This is known as the crack-the-whip effect. When pulling a triple, increase your following distance, avoid sudden moves, and steer gently. At night, don't drive faster than your headlight range.

Not quite. The answer is the trailer's emergency brakes to come on.

The trailer air supply valve (which is manually controlled by the red dashboard knob) senses air pressure in the supply (emergency) line. If air pressure in the supply line is lost, the trailer air supply valve will close automatically, and the resulting loss of air pressure in the tractor protection valve will cause it to close as well. And loss of pressure in the supply line will cause the trailer emergency (spring) brakes to come on.

Not quite. The answer is A 5-axle tractor towing a 52-foot trailer

When any vehicle turns, its rear wheels will follow a shorter path than its front wheels. This is called off-tracking or "cheating." The longer the vehicle, the greater the difference. In a combination vehicle, the trailer's wheels will off-track more than the tractor's rear wheels. In a double or triple combination vehicle, the wheels of the last trailer will off-track the most.

Not quite. The answer is to test the trailer brakes.

The trailer hand valve (also known as a trolley valve or Johnson bar) controls only the trailer brakes, not the tractor brakes. You can use it to test the trailer brakes. Don't use it while you're driving, though. If you apply it while you're driving, you'll brake the trailers but not the tractor, which can cause a skid. Instead, use the foot brake, which sends air to the tractor brakes as well as the trailer brakes.

Not quite. The answer is over the locking lever.

The safety latch should be in position over the fifth wheel locking lever. On some vehicles, you may have to position it manually.

Not quite. The answer is None

If there is space between the lower and upper fifth wheel after you have finished coupling, something is wrong. Perhaps the kingpin is on top of the closed fifth-wheel jaws, which could result in the trailer coming loose. Don't start to drive until you have identified and fixed the problem.

Not quite. The answer is The rear wheels of the last trailer

Off-tracking is defined as the different paths taken by the front and rear wheels in a turn. The longer the vehicle, the greater the difference will be. Thus, the wheels on the front trailer will offtrack more than the tractor's rear wheels, and the wheels on the rearmost trailer will offtrack most of all.

Not quite. The answer is Both of these statements are true.

The trailer hand valve (also known as a trolley valve or Johnson bar) controls only the trailer brakes, not the tractor brakes. You can use it to test the trailer brakes. Don't use it while you're driving, though. If you apply it while you're driving, you'll brake the trailers but not the tractor, which can cause a skid. Instead, use the foot brake, which sends air to the tractor brakes as well as the trailer brakes.